Abstract:Electric solid propellants are advanced solid chemical rocket propellants that can be controlled (ignited, throttled and extinguished) through the application and removal of an electric current. This behavior may enable the propellant to be used in multimode propulsion systems utilizing the ablative pulsed plasma thruster. The performance of an electric solid propellant operating in an electrothermal ablation-fed pulsed plasma thruster was investigated using an inverted pendulum micro-newton thrust stand. The impulse bit and specific impulse of the device using the electric solid propellant were measured for short-duration test runs of 100 pulses and longer-duration runs to end-of-life, at energy levels of 5, 10, 15 and 20 J. Also, the device was operated using the current state-of-the-art ablation-fed pulsed plasma thruster propellant, polytetrafluoroethylene (PTFE). Impulse bit measurements for PTFE indicate 100 ± 20 μN-s at an initial energy level of 5 J, which increases linearly with energy by approximately 30 μN-s/J. Within the error of the experiment, measurements of the impulse bit for the electric solid propellant are identical to PTFE. Specific impulse when operating on PTFE is calculated to be about 450 s. It is demonstrated that a surface layer in the hygroscopic electric solid propellant is rapidly ablated over the first few discharges of the device, which decreases the average specific impulse relative to the traditional polytetrafluoroethylene propellant. Correcting these data by subtracting the early discharge ablation mass loss measurements yields a corrected electric solid propellant specific impulse of approximately 300 s.

Impulse Measurement Methods for Pulsed Laser Ablation Propulsion

Impulse and Performance Measurements of Electric Solid Propellant in a Laboratory Electrothermal Ablation-Fed Pulsed Plasma Thruster

Impulse coupling measurement of metallic and carbon targets during laser ablation through ballistic pendulum experiments and simulations

Multi-use Laser Impulse Pendulum and Laser Propulsion Parameters Measurement

Numerical study on impulse characteristics of laser-supported air-breathing pulsed detonation thrusters

Experimental Investigation of the Reflection Mode Micro Laser Propulsion under Highly Frequent and Multi Pulse Laser

Experimental Investigation of Impulsive Coupling Characteristics of Asteroid Simulants Based on Laser Ablation Propulsion

Experimental Investigation on Ablation Mode of Laser Propulsion

Brief Review on Pulse Laser Propulsion

An Experimental and Conceptual Investigation of Laser Micro Propulsion

Characteristic investigation of ablative laser propulsion driven by nanosecond laser pulses

Experimental Investigation of Liquid-Propellant Laser Propulsion with A Horizontal Momentum Measuring Lever

Measurements of Impulse Coupling Coefficient for Laser Propulsion with Liquid Propellants

Analytical and Numerical Study of the Air Breathing Model for Laser Propulsion

Laser Micro-Impulse Torsion Pendulum

Influencing Factors on Propulsive Performances of Water Droplets for Laser Propulsion

Laser Propulsion in Development

Influence of Different Energy Supply Methods on Performance of Ablative Pulsed Plasma Thrusters

An impulsive thrust balance for applications of micro-pulsed plasma thrusters

Micro Thruster Measurement Using Pendulum System And Interferometry

Measurements of the impulse coupling coefficient for gas breakdown laser propulsion