Abstract:Introduction Due to its remarkable stoichiometric flexibility and surface chemistry, hydroxyapatite (HAp) is the fundamental structural material in all vertebrates. Natural HAp9s properties inspired an investigation into silicon nitride (Si 3 N 4 ) to see if similar functionality could be engineered into this bioceramic. Biological and in situ spectroscopic analyses were used to monitor the response of osteosarcoma cells (SaOS-2) to surface-modulated Si 3 N 4 and a titanium alloy after long-term in vitro exposure. Materials and Methods Four groups of Si 3 N 4 discs, O12.7×1.0mm, (Amedica Corporation, Salt Lake City, UT USA) were subjected to surface treatments: (i) “As-fired;” (ii) HF-etched (5% HF solution for 45 s); (iii) Oxidized (1070°C for 7 h); and (iv) Nitrogen-annealed (1400°C for 30 min, 1.1 bar N 2 gas). 1 Titanium alloy discs (Ti6Al4V, ASTM F136) were used as a control group. SaOS-2 cells cultured for 24 h at 37 ° C were deposited (5×10 5 cells/ml) and incubated on the UV sterilized discs in an osteogenic medium for 7 days at 37°C. Cell proliferation was monitored using scanning electron and laser microscopy. The Receptor Activator of NF-kB Ligand (sRANKL) and the insulin growth factor 1 (IGF-1) were used to evaluate osteoclast formation and cell proliferation efficiency, respectively. In situ Raman spectroscopy was employed to monitor metabolic cell activity. Statistics (n≥3) were analyzed using the Student9s t-test or one-way Analysis of Variance with p Results Results are presented in Figure 1(a)∼(c) for HAp formation, free sRANKL, and IGF-1, respectively. These data indicate that the N 2 -annealed Si 3 N 4 samples had the highest amount of HAp formation followed by the as-fired, oxidized, and HF samples. The Ti-alloy showed moderate HAp formation; but it had a higher amount of free sRANKL as compared to all Si 3 N 4 samples. These data suggest that the Si 3 N 4 represented a friendlier environment for SaOS-2 cell differentiation. The IGF-1 concentration did not differ among the Si 3 N 4 samples, but they were all higher than the Ti-alloy. Higher IGF-1 stimulates cells to proliferate and differentiate. 2 In Figure 2, in situ collected Raman spectra confirmed enhanced formation of HAp on the Si 3 N 4 samples, especially the N 2 -annealed material. Discussion Enhanced apatite formation was found to originate from a high density of positively charged surface groups, including nitrogen vacancies (V N 3+ ) and nitrogen N-N bonds (N 4+ ). 3 These surface charges promoted binding of proteins onto the negatively charged Si 3 N 4 surface. A dipole-like-charge of V N 3+ /N 4+ and SiO − defective sites is proposed as a mechanism to explain the attraction between proteins and the COO − and NH 2+ terminus, respectively. This is analogous to the mechanism occurring in hydroxyapatite where protein groups are displaced by positively charged calcium loci (Ca + ) and off-stoichiometry phosphorus sites (PO 4 2− ). Conclusion Osteoblast proliferation and apatite-growth are important properties in regenerative bone therapies. In general, these properties were pronounced on all of the Si 3 N 4 substrates; but achieved maximum values on the N 2 -annealed Si 3 N 4 .

Human Osteoblasts Grow Transitional Si/N Apatite in Quickly Osteointegrated Si3N4 Cervical Insert.

Silicon nitride enhances osteoprogenitor cell growth and differentiation via increased surface energy and formation of amide and nanocrystalline HA for craniofacial reconstruction

Silicon Nitride Induces Osteoconduction Via Activated Mitochondrial Oxidative Phosphorylation and Neovascularization

IN SITU MONITORING OF OSTEOSARCOMA CELLS ON SURFACE-MODULATED SILICON NITRIDE AND TITANIUM BIOMATERIALS

Silicon Nitride: A Synthetic Mineral for Vertebrate Biology

The Role of Nitrogen Off-Stoichiometry in the Osteogenic Behavior of Silicon Nitride Bioceramics.

Bioactive Silicon Nitride: A New Therapeutic Material for Osteoarthropathy

ANTI-INFECTIVE AND OSTEOINTEGRATION CHARACTERISTICS OF SILICON NITRIDE SPINAL FUSION IMPLANTS

Surface Modulation of Silicon Nitride Ceramics for Orthopaedic Applications

Incorporating Si3N4 into PEEK to Produce Antibacterial, Osteocondutive, and Radiolucent Spinal Implants

In Situ Spectroscopic Screening of Osteosarcoma Living Cells on Stoichiometry-Modulated Silicon Nitride Bioceramic Surfaces

Biological Response of Human Osteosarcoma Cells to Si3N4-doped Bioglasses

Understanding Silicon Nitride’s Biological Properties: From Inert to Bioactive Ceramic

Silicon Nitride As a Biomaterial

Mechanical properties and in vitro bioactivity of silicon nitride ceramics with SiO2 , CaO, and MgO additions

Characterization and In-Vitro Assessment of Silicon-Based Apatite Microspheres for Bone Tissue Engineering Applications

Core-shell-structured Nonstoichiometric Bioceramic Spheres for Improving Osteogenic Capability

Enhanced Bioactivity of Si3N4 Through Trench-Patterning and Back-Filling with Bioglass®

Enhanced Bioactivity and Bacteriostasis of PEEK Polymers Through Incorporation of Silicon Nitride Particles

Osteoblast Growth in Quaternized Silicon Carbon Nitride Coatings for Dental Implants

A hierarchical nanostructural coating of amorphous silicon nitride on polyetheretherketone with antibacterial activity and promoting responses of rBMSCs for orthopedic applications.