Abstract:Future actively cooled space-borne observatories for the far-infrared, loosely defined as a 1--10 THz band, can potentially reach a sensitivity limited only by background radiation from the Universe. This will result in an increase in observing speed of many orders of magnitude. A spectroscopic instrument on such an observatory requires large arrays of detectors with a sensitivity expressed as a noise equivalent power NEP = 3 $\times 10^{-20}$ $W\surd{Hz}$. We present the design, fabrication, and characterisation of microwave kinetic inductance detectors (MKIDs) for this frequency range reaching the required sensitivity. The devices are based on thin-film NbTiN resonators which use lens-antenna coupling to a submicron-width aluminium transmission line at the shorted end of the resonator where the radiation is absorbed. We optimised the MKID geometry for a low NEP by using a small aluminium volume of $\approx$ 1$\mu m^3$ and fabricating the aluminium section on a very thin (100 nm) SiN membrane. Both methods of optimisation also reduce the effect of excess noise by increasing the responsivity of the device, which is further increased by reducing the parasitic geometrical inductance of the resonator. We measure the sensitivity of eight MKIDs with respect to the power absorbed in the detector using a thermal calibration source filtered in a narrow band around 1.55 THz. We obtain a NEP$_{exp}(P_{abs})\:=\:3.1\pm0.9\times10^{-20}\:W\surd{Hz}$ at a modulation frequency of 200 Hz averaged over all measured MKIDs. The NEP is limited by quasiparticle trapping. The measured sensitivity is sufficient for spectroscopic observations from future, actively cooled space-based observatories. Moreover, the presented device design and assembly can be adapted for frequencies up to $\approx$ 10 THz and can be readily implemented in kilopixel arrays.

A Route to Large-Scale Ultra-Low Noise Detector Arrays for Far-Infrared Space Applications

Demonstration of ultra-low noise equivalent power using a longitudinal proximity effect transition-edge sensor

Design of Large Low Noise Transition Edge Sensor Arrays for Future FIR Space Missions

Noise Reduction Methods for Large-scale Intensity-mapping Measurements with Infrared Detector Arrays

Progress towards a megapixel linear-mode avalanche photodiode array for ultra-low background shortwave infrared astronomy

Ultra-sensitive Super-THz Microwave Kinetic Inductance Detectors for future space telescopes

High-Sensitivity Kinetic Inductance Detector Arrays for the PRobe Far-Infrared Mission for Astrophysics

Monolithic Kilopixel Silicon Microlens Arrays for Future Far-Infrared Observatories

Mid-infrared detector development for the Origins Space Telescope

Fabrication of phononic filter structures for far-IR/sub-mm detector applications

On-Chip Infrared Spectroscopic Sensing: Redefining the Benefits of Scaling

A New Large-Well 1024x1024 Si:As Detector for the Mid-Infrare

First tests of a 1 megapixel near-infrared avalanche photodiode array for ultra-low background space astronomy

A 64-pixel mid-infrared single-photon imager based on superconducting nanowire detectors

Development of long-wavelength infrared detector and its space-based application requirements

Development of large, fast, low noise x-ray CCD for future space missions

Efficient ultra-broadband low-resolution astrophotonic spectrographs

Infrared Detector Arrays for Astronomy

GHz Low Noise Short Wavelength Infrared (SWIR) Photoreceivers