Abstract:This paper presents a 0.2 similar to 3.8-GHz in-band (IB) full-duplex (FD) mixer-first receiver based on a vector self-interference (SI) canceller. To ensure the wideband orthogonality of the reconstructed SI signal while minimizing the noise figure (NF) degradation in FD mode, a low insertion loss two-stage polyphase filter (PPF) with a lacking resistance and capacitance (LRC) structure is used in the SI canceller. A 6-bits passive capacitor digital to analog converter (C-DAC) attenuator not only realizes the high-precision amplitude adjustment of the reconstructed SI signal but also avoids the linearity limitation of the back-end modules of the canceller and reduces the noise contribution of the front-end modules at the canceller output. A four-phase mixer-first receiver with enhanced out-of-band (OOB) interference suppression is designed to provide sufficient linearity to reduce the SI-induced nonlinear distortion. As a proof of concept, a prototype FD receiver is fabricated in CMOS 65 nm technology and measured in chip-on-board (COB) package. Measurement results show that it can operate in the frequency range of 0.2 similar to 3.8-GHz with more than 25 dB SIC amount for 10 MHz bandwidth (BW) 64-QAM modulated signals in fixed (30 dB) channel attenuation test setup. The receiver achieves OOB input-referred third-order intercept point (OOB-IIP3) of +24 dBm and OOB input-referred second-order intercept point (OOB-IIP2) of +82 dBm at 1-GHz local oscillator (LO) frequency. In FD mode, the NF degradation is <= 1.5 dB. The effective IB-IIP3 and effective IB-IIP2 are enhanced by 15 dB and 28 dB, respectively. The power consumption of entire FD receiver including the SI canceller is less than 44 mW. The active chip area is 0.55 mm(2).

A Digital IQ Imbalance Self-Calibration in FDD Transceiver.

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

A Blind Calibration Model for I/Q Imbalances of Wideband Zero-IF Receivers

Low-Complexity Calibration Of Joint Tx/Rx I/Q Imbalance In Wideband Direct-Conversion Transceiver

A Hybrid Scheme for TX I/Q Imbalance Self-Calibration in a Direct-Conversion Transceiver

Digitally Assisted IIP2 Calibration for CMOS Direct-Conversion Receivers

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

A Hybrid Approach To I/Q Imbalance Self-Calibration In Reconfigurable Low-If Receivers

A Simple Over-The-Air Hardware Calibration Procedure In Tdd Systems

Three-Stage Treatment of TX/RX IQ Imbalance and Channel with CFO for SC-FDE Systems

A new method to simultaneously estimate TX/RX IQ imbalance and channel for OFDM systems

Experimental Demonstration of Simultaneously Precise Tx and Rx Skew Calibration for Coherent Optical Transceiver

I/Q imbalance calibration based on simulated annealing algorithm

Joint Estimation and Compensation of TX and RX IQ Imbalance for Direct-Conversion Transceiver

Time Domain Compensation of I/Q Imbalance in Digital Receivers

System impact and calibration method of power imbalances for a dual-polarization in-phase/quadrature optical transmitter

Estimation of Tx I/Q Imbalance at the Rx Side with Rx I/Q Imbalance and Carrier Frequency Offset for Ofdm Systems

Single-shot Characterization of Frequency-resolved Imbalance in Coherent Transceivers Based on Inter-channel Response Ratio

A 0.2~3.8-Ghz Full-Duplex Receiver with More Than 25 Db Self-Interference Cancellation Using a C-DAC-Based Vector Canceller.

Automatic IQ Phase Calibration Design in a 2.4ghz Direct Conversion Receiver

Low-Complexity Blind I/Q Estimation and Compensation of Wideband Zero-IF Receivers