Abstract:In this work, theoretical kinetic curves of both single- and multi-step reaction mechanisms were simulated by using different sets of kinetic parameters. Various isoconversional methods were applied for the kinetic analysis of these curves so that the corresponding activation energy vs. conversion degree curves were obtained and then compared with the energy values used in the simulations. For single-step reaction mechanisms Friedman method resulted to be the most accurate while for multi-step reaction mechanisms, Kissinger–Akahira–Sunose and Coats–Redfern methods led to the most accurate estimation of the activation energy. On the other hand, conversion rate curves of different single-step reaction mechanisms were fitted with two kinds of peak functions (normalized Fraser–Suzuki and generalized logistic) so that the relationships between the parameters of these functions and the kinetic parameters used in the simulations were obtained. These relationships were then used in the mathematical deconvolution analysis of conversion rate curves simulated for multi-step reaction mechanisms. In general, the curves resulting from deconvolution fitted quite well the simulated conversion rate curves and the analysis of the resulting single-step reaction curves with Kissinger method led the kinetic parameters close to the ones used in the simulations. Finally, a similar kinetic analysis was applied to experimental thermogravimetric measurements taken both under N 2 and air for two phase change materials (PCMs) based on polyethylene glycol, PEG6000 and PEG12000. Activation energy values obtained with isoconversional methods for the measurements under N 2 , varied from 40 kJ mol −1 at low conversions up to 150 kJ mol −1 at high conversions, whereas for the measurements under air the energy values remained almost constant in the range of 50–75 kJ mol −1 . The lower activation energies obtained for the measurements under air are clearly associated with the polymer combustion. The experimental conversion rate curves were deconvoluted with the most appropriate peak functions so that the possible single-step reaction mechanisms occurring in these PCMs were separated and further analyzed with Kissinger method. The activation energies obtained with this method were in good agreement with the values resulting from the isoconversional methods.

Studies on Thermokinetic of Chlorella Pyrenoidosa Devolatilization Via Different Models

Experimental Analysis of Intrinsic Kinetics and Rate Profiles for Coal Char Conversion under Different Atmospheres

Kinetic Analysis of Algae Gasification by Distributed Activation Energy Model

Pyrolysis of Algal Biomass: Determination of the Kinetic Triplet and Thermodynamic Analysis.

Thermal Behavior and Kinetic Mechanism of Microalgae and Model Compounds

Analysis of Volatile Species Kinetics During Typical Medical Waste Materials Pyrolysis Using a Distributed Activation Energy Model.

Chemical kinetic models, reaction mechanism estimation and thermodynamic parameters for the thermochemical conversion of solid wastes: Review

Kinetic study and modelling of drying of Chlorella vulgaris

New Method for Kinetic Analysis of Decomposition of Biomass Materials—based on Critical Analysis of Moll Method

A Comparison of a Single Reaction Model with a Distributed Activation Energy One Based on Coal Pyrolysis Kinetics

Assessment of isoconversional methods and peak functions for the kinetic analysis of thermogravimetric data and its application to degradation processes of organic phase change materials

Iso-conversional Kinetics of Low-Lipid Micro-Algae Gasification by Air

Intrinsic Kinetic Modeling of Thermal Dimerization of C5 Fraction

Kinetics modeling of co-pyrolytic decomposition of binary system of cellulose, xylan and lignin

Kinetic Modeling of the Devolatilization of Pulverized Coal, Poplar Wood, and Their Blends in a Thermogravimetric Analyzer and a Flat Flame Reactor

Kinetic Modeling of Biomass Components Pyrolysis Using a Sequential and Coupling Method

Kinetic Model Implementation of Fluidized Bed Devolatilization

Kinetic Analysis Based on the Kinetic Compensation Effect and Optimization Calculation

A green approach towards adoption of chemical reaction model on 2,5-dimethyl-2,5-di-(tert-butylperoxy)hexane decomposition by differential isoconversional kinetic analysis

Thermokinetic Studies of Dicumyl Peroxide

From biomass to Energy: Investigating Chlorella pyrenoidosa's potential for fuel and carbon materials