Abstract:An advanced sol-gel method is developed via combined ultrasound-microwave irradiation and utilized for the crystallization of pristine and samarium doped zinc oxide nanorods. Organic structure directing agents directed one dimensional growth and air-annealing was applied as post-thermal treatment. Microstructural, optical, and solid state survey was pursued by PXRD, FESEM, TEM, EDS, FTIR, DRS, PL, micro-Raman, H2-TPR, and ESR techniques. Phase analysis by diffraction patterns confirmed the efficacy of irradiation strategy as it improves the crystallinity degree, expedites the hexagonal close pack morphology, and conducts lattice imperfection. Accordingly, aspect ratio and electronic evolution parallel to dopant content is favored. Electron microscopy demonstrated the flake-like rearrangement of nanorods as well as a structure-related growth where a direct proportion exists between atomic packing factor in lattice and aspect ratio. Textural investigation by EDS and FTIR rejected the presence of any impurity verifying an integrated composition. Reflectance and luminescence spectra exhibited characteristic optical behavior with shifts corresponding to dopant concentration. Also, band gap energies increased with samarium addition depicting an opposite trend with respect to unit cell variation. Finally, Raman, TPR, and ESR spectra provided detailed dopant-dependent trends on the internal solid state and defect chemistry of the nanorods. In this regard, maximum shifts in E2high and E1LO phonon modes duly correlated with the vibrations of zinc and oxygen atoms, surface oxygen and bulk ZnO reduction bands, emergence and alteration of samarium centers, along with the dominance of zinc and oxygen vacancies were all resulted due to the utmost lattice imperfection in SZO1.

Enhancement and refinement of SSP method for XRD analysis and investigation of structural properties of pure and Ca-doped zinc oxide

Effect of Solution Concentrations on Crystal Structure, Surface Topographies and Photoluminescence Properties of ZnO Thin Films

Preparation and Characterization of Na-doped ZnO Thin Films by Sol–gel Method

Surface Morphology and Optical Properties of Na-doped ZnO Thin Films

Microstructure, surface morphology and optical properties of Na x Cu y Zn 1− x − y O thin films

Preparation and Characterization of Mg-doped ZnO Thin Films by Sol–gel Method

X-ray peak broadening and strain-driven preferred orientations of pure and Al-doped ZnO nanoparticles prepared by a green gelatin-based sol-gel method

High Speed Shearing: A Novel Approach for High-Quality ZnO Nanoparticle Synthesis and Photocatalytic Activity Control

Study on structural and optical properties of Sn-doped ZnO nanoarrays

Structural and Optical Studies on Cr-Doped ZnS Nanoparticles Prepared by Flat Co-precipitation Method

A comparative approach for estimating microstructural characteristics of BaTi1−xZrxO3 (0.0 ≤ x ≤ 0.3) nanoparticles via X-ray diffraction patterns

Crystallization and solid solution attainment of samarium doped ZnO nanorods via a combined ultrasonic-microwave irradiation approach

Estimation of lattice strain in ZnO nanoparticles: X-ray peak profile analysis

Structural and Optical Analysis of 1D Zinc Oxide Nanoparticles Synthesized Via Hydrothermal Method

Structural, Optical And Magnetic Properties Of Zn0.97-Xalxcr0.03s Nanoparticles

Normality Effect on Characterization of Chemically Synthesized ZnO Nanoparticles

Structural, Morphological and Optical Characterization of Tin Doped Zinc Oxide Thin Film by (SPT)

Investigation of dilute aluminum doped zinc oxide thin films: structural and morphological properties for varies applicationss

Optical Investigation on Cadmium-Doped Zinc Oxide Nanoparticles Synthesized by Using A Sonochemical Method

X-ray Diffraction, XPS, and Raman Spectroscopy of Coated ZnO:Al (1—7 at%) Nanoparticles

An approach to the micro-strain distribution inside nanoparticle structure