Abstract:Flash sintering is a novel field-assisted sintering technology for ceramics that allows a dramatic reduction in processing time and temperature. Since 2010, when flash sintering was first reported, it has been a focus of research interest in the field of materials science. Recent study results have confirmed that the sintering temperature decreases with the strength of the applied electric field; for some ceramics, the sintering temperature can be lowered even to room temperature. This represents an innovative breakthrough for ceramic sintering at ultra-low temperatures. However, once the electric field strength in flash sintering is increased, new questions and challenges arise, such as whether or not partial discharge occurs in the green body if under electro-thermal coupling stress, how to quantitatively analyse the impact of discharge on sintering, and, moreover, whether the sintering mechanism under a strong electric field is consistent with that under a weak electric field. These research questions require knowledge of partial discharge detection, dielectric theory, and other topics that are beyond the scope of materials science. To address this need, this review summarises the work carried out in flash sintering with a strong electric field from the perspective of high voltage and insulation technology. First, the flash sintering process and mechanism are briefly introduced. Then, the published literature on flash sintering with a strong electric field for various ceramic materials is summarised in depth. In addition, experimental phenomena that are observed in flash sintering with a strong electric field, such as flash and blackening, are discussed. Finally, some suggestions for future work are presented. It is anticipated that the knowledge gap between different areas of study can be filled by this review.

Defects in flash-sintered ceramics and their effects on mechanical properties

&Lt;i>in Situ</i> Studies on Defects Formation Dynamics in Flash-Sintered TiO &Lt;sub>2</sub>

Flash sintering can induce an anisotropic microstructure in ceramics. A phase field modeling insight

Effects of electric field on microstructure evolution and defect formation in flash-sintered TiO2

High Temperature Deformability of Ductile Flash-Sintered Ceramics Via In-Situ Compression

Study of Deformation Mechanisms in Flash-Sintered Yttria-Stabilized Zirconia by In-Situ Micromechanical Testing at Elevated Temperatures

Effects of incubation on microstructure gradient in flash-sintered TiO2

Review of flash sintering with strong electric field

Defects and Aliovalent Doping Engineering in Electroceramics

Staged Microstructural Study of Flash Sintered Titania

The impact of flash sintering on densification and plasticity of strontium titanate: High heating rates, dislocation nucleation and plastic flow

In-situ High-Temperature Micromechanical Behavior of Flash-Sintered Strontium Titanate

Key microstructural characteristics in flash sintered 3YSZ critical for enhanced sintering process

Promoting microstructural homogeneity during flash sintering of ceramics through thermal management

Microstructure and defect gradients in DC and AC flash sintered ZnO

Electric field-induced grain boundary degradation mechanism in yttria stabilized zirconia

Influence of current density on microstructure and dielectric properties during the flash sintering of strontium titanate ceramics

In situ studies on temperature‐dependent deformation mechanisms of Al2O3 prepared by spark plasma sintering

Uncovering electromigration effect on densification during electrical field assisted sintering

Enhancing microstructure homogeneity and electrical conductivity in flash-sintered 8YSZ: Impact of electric-current ramp control and thermal insulation

Revealing correlation of core‒rim structures, defects and stacking-faults in SiC ceramics by integrated scanning electron microscopy