Abstract:Herein, a quaternary ammonium surfactant with dual heads and tails, N1,N1,N1,N3,N3-pentamethyl-N3-(3-(2-tetradecylhexadecanamido)propyl)propane-1,3-diaminium dibromide, abbreviated as Di-C14-N2, was synthesized. For the first time, clear observation of aggregate structures formed by surfactants in pure glycerol systems was achieved using cryogenic transmission electron microscopy (cryo-TEM). The system's rheological properties were analyzed using both steady-state shear and oscillatory rheological measurements. The lubricating efficiency of the Di-C14-N2 glycerol solution was assessed for its tribological properties using a tribological wear tester, white light interferometer, and scanning electron microscope. In glycerol, Di-C14-N2 formed long wormlike micelles, which resulted in a glycerol solution with the zero-shear viscosity of 1013 Pa·s at 90 mM, which is the most viscous glycerol system up to now. The system displayed distinct rheological properties from the aqueous system, as evidenced by two intersections in the loss and storage moduli. The formed wormlike micelles in glycerol lead to a significant alteration in the viscoelasticity of the system, thus endowing the Di-C14-N2 glycerol solution with potential as an eco-friendly lubricant. The friction coefficient of the system was found to be 23% lower and the wear rate was 83% lower than that of pure glycerol after the addition of Di-C14-N2. This demonstrates that the addition of Di-C14-N2 greatly improves the frictional properties of pure glycerol. This study offers the possibility of directly observing the aggregate structures formed by surfactants in pure glycerol systems. It contributes to the exploration of the self-assembly behavior of surfactants in nonaqueous polar media, thereby aiding in a deeper understanding of the correlation between molecular structure, mesoscale structure, and macroscopic properties.

Diffuse-In/Condense-Out Behavior of Glycerol Induces Formation of Composite Membranes with Uniform Pores

Cellulose nitrate membrane formation via phase separation induced by penetration of nonsolvent from vapor phase

Mass transport to generate the channels in cellulose polymers by vacuum-assisted process

Formation Mechanism of Ordered Porous Nitrocellulose Membranes by Breath Figure Templating

Influence of additives on phase separation process of PVDF solution and membrane morphology

Seeding nuclei for the phase-separation of cellulose acetate solution

A strategy for processing cellulose acetate into a uniform porous structure utilizing NaCl as additive

Effect of Solvent and Coagulation on Morphologies of Membrane

Synthesis of an Amphiphilic Glucose‐carrying Graft Copolymer and Its Use for Membrane Surface Modification

Derivation of porous cellulose propionate using hydrated hydroxyl groups and hydraulic pressure

Study of the Porosity in Cellulose Acetate Membranes by 3γ Annihilation of Positrons

A method of improving the dispersion of graphene nanoplatelets in cellulose acetate based composite

Green glycerol tailored composite membranes with boosted nanofiltration performance

Study on the Preparation of Cellulose Acetate Separation Membrane and New Adjusting Method of Pore Size

Glycopolymer-filled Microporous Polypropylene Membranes for Pervaporation Dehydration

Influence of the Dilute‐solution Properties of Cellulose Acetate in Solvent Mixtures on the Morphology and Pervaporation Performance of Their Membranes

Influence of Glycerol on the Surface Morphology and Crystallinity of Polyvinyl Alcohol Films

Preparation and Properties of Cellulose Triacetate (CTA)-PVDF Composite Membrane with Hydrophobic/hydrophilic Properties for Membrane Distillation

Effect of polytetrafluoroethylene hollow fiber microstructure on formaldehyde carbonylation performance in membrane contactor

Self-Diffusion of Glycerol in $γ$-Alumina Nanopores: Understanding the Effect of Pore Saturation on the Dynamics of Confined Polyalcohols

Wormlike Micellar Glycerol Solutions Formed from a Double-Tailed Surfactant with Two Quaternary Ammonium Head Groups