Abstract:Surface integrity has a significant impact on the performance and life cycle of the blisk blade. Residual stress, as one of the important characterization parameters of surface integrity, is closely related to the performance of the aeroengine blisk blade. A certain interval of residual compressive stress can significantly inhibit the generation of microcracks. This paper proposes an optimization method of polishing process parameter interval based on sensitivity analysis. This research studied the effect of polishing parameters of the alumina ACW (abrasive cloth wheel) on the surface residual stress of the GH4169 superalloy blisk blade. Firstly, the experiment was designed by four factors and three levels response surface method, the multiple regression of the experimental data based on Minitab software was used to get a prediction model of polished surface residual stress. And an analysis of variance was performed on the model. Subsequently, the model of relative sensitivity was got based on this model. The sensitivity order of polishing surface residual stress to each polishing parameter was obtained. And the judging method of stable interval and instable interval was put forward. Then, a parameter interval optimization method was proposed, and the optimal interval of process parameters was obtained. Finally, a polishing verification experiment was performed. The results show that: for the polishing of GH4169 superalloy blades, the surface residual stress is most sensitive to the feed rate vf of the ACW, followed by the granularity p and the rotation rate ω, and the compression depth ap is the least sensitive. The optimal interval of polishing process parameters is: the rotation rate ω is [11000 r/min, 11500 r/min], the feed rate vf is [100 mm/min, 200 mm/min], the compression depth ap is [0.6 mm, 1.0 mm], and the granularity p is [400 #, 600 #]. The optimized polishing process parameters can obtain a large and stable surface residual compressive stress, which is helpful to increase fatigue strength of the blisk blade.

An Integrated Polishing Method for Compressor Blade Surfaces

Effect and Mechanism of Roughness on the Performance of a Five-Stage Axial Flow Compressor

Machining behavior and experimental investigation of ultrasonic vibration assisted belt flapwheel flexible polishing

A synchronous polishing method for aero-engine blade based on multi-spindle machine tool

A novel polishing technology for leading and trailing edges of aero-engine blade

A novel high-quality and high-efficiency immersion fluid chemical mechanical polishing process for integral impellers

A Robotic Polishing Trajectory Planning Method Combining Reverse Engineering and Finite Element Mesh Technology for Aero-Engine Turbine Blade TBCs

A Path Planning Method for Polishing Thermal Barrier Coatings on the Surface of Aero-Engine Blades Based on Point Cloud Slicing

A Trajectory planning technique for grinding and polishing aerospace turbine blades' thermal barrier coatings based on PCL point cloud processing

Collaborative improvement of profile accuracy and aerodynamic performance in robotic grinding of transonic compressor blade leading edge

Novel rotary chemical mechanical polishing on an integral impeller

Quantitative finite element analysis of microscopic surface formation for TC4 aeroengine blade polishing using single-grain method

A review of surface quality control technology for robotic abrasive belt grinding of aero-engine blades

A robotic polishing trajectory planning method for TBCs of aero-engine turbine blade using measured point cloud

Research on computer controlled ultra-precision polishing of freeform surfaces

Sensitivity analysis and parameter interval optimization for residual stress in polishing process of GH4169 blisk blade

Process Optimization for Robotic Ultrasonic Strengthening of Aviation Blade Surfaces Based on Intelligent Compliance Control

Clamping Error Calibration Algorithm of Aero-Engine Blade Surface Polishing

Combined Processing Chain for Freeform Optics Based on Atmospheric Pressure Plasma Processing and Bonnet Polishing.

Numerical and experimental investigation on the material removal profile during polishing of inner surfaces using an abrasive rotating jet

Research on Formation Mechanism and Optimization Method of Surface Waviness of TC4 Blisk Blade