Effect of Grouser Height on Tractive Performance of Tracked Mining Vehicle

Junzheng Li,Shaojun Liu,Yu Dai
DOI: https://doi.org/10.1007/s40430-016-0641-4
IF: 2.361
2016-01-01
Journal of the Brazilian Society of Mechanical Sciences and Engineering
Abstract:The aim of this study is to establish a single track shoe with grouser driving model to optimize the track structural parameters and improve the tractive performance of the tracked mining vehicle on soft sediments. The calculation formula of each component force and total driving force about grouser height was obtained through theoretical analysis. The basic parameters and the relationship of mechanical properties for computer simulation were also obtained by the testing experiment using soil simulation whose main physical and mechanical properties are close to the deep-sea sediments. The computer simulation results show that the total driving force of the track improved rapidly with the increases of the grouser height and the slip rate. It keeps rising until it reaches a maximum value. And then it will maintain a steady value when the slip rate exceeds 40 %. The total driving force also improved with the increase of the ratio (slip rate/grouser height). When the grouser height is in the range of 0–15 cm, the total driving force keeps increasing gradually with the increase of the slip rate until it reached the stable state. When the grouser height is in the range of 15–30 cm, the total driving force keeps increasing to a maximum value rapidly with the increasing of slip rate first, and then keeps decreasing gradually. The greater the increase of grouser height, the faster the decrease of the total driving force.
What problem does this paper attempt to address?