Abstract:Abstract This paper documents CFD simulations of the gas hold-up (ɛ g ) and volumetric mass transfer coefficient (K L a) for three kinds of airlift reactors (ALRs) namely, conventional ALR, ALR with net draft tube (ALR-ndt), and packed-bed ALR with net draft tube (PBALR-ndt). The 3D two-fluid Eulerian-Eulerian model was adopted to predict the influence of superficial gas velocity on ɛ g and K L a. The simulation results were consistent with the trends described previously in the experimental work regarding ɛ g and K L a values and a good agreement was obtained (absolute error less than 20 %). Based on the simulation results, axial flow is the dominant flow in the conventional ALR while in ALR-ndt and PBALR-ndt radial flow streamlines are appeared in the reactors due to the presence of concentric net draft tube which improves their performance. The effective role of the net draft tube is proven since consequence of generation of small bubbles by passing through net draft tube is the entrainment of a larger percentage of gas bubbles from the riser into the downcomer which results in improvement of gas holdup and the K L a values. An exponential correlation is used for relating gas hold-up and mass transfer coefficient. Higher power obtained for ALR-ndt and PBALR-ndt (n ≈ 1.22) compared to ALR (n = 0.95) was indicative of high sensitivity of K L a value to gas hold-up in these reactors due to presence of the concentric net draft tube. The CFD modeling is considered to be an invaluable tool allowing us to analyze and visualize the impact of fluidic forces on hydrodynamic properties and consequently, reactor performance.

Effects of Different Draft Baffles on the Hydrodynamics in Internal-Loop Airlift Reactors

CFD Simulation for Up Flow Jet-Loop Reactors by Use of Bi-Dispersed Bubble Model

Gas Holdup and Liquid Velocity Distributions in the Up Flow Jet-Loop Reactor

The Influence of Draft Tubes on the Mass Transfer and Mixing Performance of a Pilot-Scale Internal-Loop Airlift Reactor

Hydrodynamic Character of Internal-Loop Airlift Reactor

Study on three-phase Newtonian fluid in an internal loop airlift reactor with a convergence-divergence draft tube

Effect of internal on the hydrodynamics in external-loop airlift reactors

Modified Airlift Reactor with a Cross-Shaped Internal and Its Hydrodynamic Simulation by Computational Fluid Dynamic Method

Hydrodynamic Behavior in Three-Phase External Loop Airlift Reactors

Liquid Circulation Hydrodynamics in an External Loop Airlift Reactor

Experimental Study on the Local Hydrodynamic Behavior of a Three-Phase External-Loop Airlift Reactor

Hydrodynamics of Three-Phase Internal-Loop Airlift Reactor with Large Particles

3D CFD Simulation of Gas Hold-up and Mass Transfer in a Modified Airlift Reactor with Net Draft Tube

Multiphase flow characteristics of a novel internal-loop airlift reactor

Hydrodynamics and Mass Transfer Characteristics in an Internal Loop Airlift Reactor with Different Spargers

Gas Holdup and Liquid Circulation in an Internal Airlift Loop Reactor

Advances in Characteristics Analysis, Measurement Methods and Modelling of Flow Dynamics in Airlift Reactors

Effect of aeration mode on the performance of center‐ and annulus‐rising internal‐loop airlift bioreactors

Hydrodynamics and Bubble Behaviour in a Three-Phase Two-Stage Internal Loop Airlift Reactor

Characteristics of Bubbly Flow, Mass Transfer, and CO 2 Absorption in a Two-Stage Internal Loop Airlift Reactor Assembly with a Diamond-Shaped Guide Baffle

Effect of Baffle on Hydrodynamics in the Air Reactor of Dual Circulating Fluidized Bed for Chemical Looping Process