Abstract:Silicon heterojunction (SHJ) solar modules gained strong interest from solar photovoltaic (PV) module manufacturers and in the global market due to their high-efficiency potential. However, the presence of an amorphous silicon layer in SHJ structures raises concerns about their stability under light exposure. In this article, we compare the stability of SHJ modules to the stability of p-type and n-type homojunction monocrystalline silicon modules and of several thin-film PV technologies. The analysis is performed in intermediate precision conditions of measurement, where the same modules are measured indoors with the same measurement procedure, same location and equipment, and over an extended period of time, during which the modules are kept stored and not exposed to light. The results from all tested SHJ modules, which were also confirmed in reproducibility conditions, show a slow exponential degradation in the dark, which is fully recovered when the module is subsequently light-soaked. With this behavior, SHJ modules recall the metastability of certain thin-film technologies. The relevance of solar PV energy in the global electricity generation mix is at the present time unquestionable and all energy outlooks now report PV as a key player in the next decades for the transition toward a decarbonized energy system. When transferred into the manufacturing and deployment phase, the ambitious solar PV targets meet, among others, the challenge of accurate and reliable power rating of the PV modules, for which differences of a fraction of a percent mean significant investment gains or losses for the manufacturers, investors, and final users. The factors that mainly affect the uncertainty of PV power rating in the production line are the accuracy in the calibration of the reference modules and their temporal stability. Among other PV technologies, SHJ, with an efficiency that now goes beyond 22% at the module level and is expected to increase further, is the fastest gaining in market share (estimated to hit 10% by 2024 and 20% by 2032). However, the observed "metastability" (i.e., the change of the electrical performance to a status with lower or higher stable power when the module is stored in the dark for a prolonged period of time), which is discussed in this article for commercial SHJ modules, although not affecting the field performance, may impact the production capacity and should be carefully addressed by SHJ module manufacturers, researchers, and testing laboratories.

The Materials Characteristic and the Efficiency Degradation of Solar Cells from Solar Grade Silicon from a Metallurgical Process Route

Investigation of Open-Circuit Voltage in Solar Grade Silicon Solar Cells from a Metallurgical Process Route and Cell’s Defect

Experimental Verification of Upgraded Metallurgical Silicon Photovoltaic Power Plant

Analysis of the Degradation of Monocrystalline Silicon Photovoltaic Modules After Long-Term Exposure for 18 Years in a Hot–Humid Climate in China

Performance analysis of crystalline silicon solar modules with the same peak power and the different structure

UMG silicon for solar PV: From defects detection to PV module degradation

Toward Efficiency Limits of Crystalline Silicon Solar Cells: Recent Progress in High‐Efficiency Silicon Heterojunction Solar Cells

On the metastability of silicon heterojunction solar photovoltaic modules

Measuring metal halide perovskite single cell degradation consistent with module-based conditions

Recent progress in silicon-based solid-state solar cells

Upgraded Metallurgical Grade Silicon for solar electricity production: a comparative Life Cycle Assessment

Effect of Temperature on Performance Parameters of Metallurgical Grade Polysilicon Solar Cells

Performance Degradation of Crystalline Silicon Solar Module in Various Ultraviolet Radiation Area

Energy performance of commercial c-Si PV modules in accordance with IEC 61853-1, -2 and impact on the annual specific yield

A Fine Model For Evaluating Actual Output Performance Of Crystalline Silicon Solar Modules

A Critical Review of The Process and Challenges of Silicon Crystal Growth for Photovoltaic Applications

Degradation pathways in perovskite solar cells and how to meet international standards

Performance degradation of commercial Ga‐doped passivated emitter and rear cell solar modules in the field

Review of technology specific degradation in crystalline silicon, cadmium telluride, copper indium gallium selenide, dye sensitised, organic and perovskite solar cells in photovoltaic modules: Understanding how reliability improvements in mature technologies can enhance emerging technologies

Comparison Of The Electrical Properties Of Perc Approach Applied To Monocrystalline And Multicrystalline Silicon Solar Cells

Detailed Performance Loss Analysis of Silicon Solar Cells using High-Throughput Metrology Methods