Abstract:Abstract Reciprocating compressor is one of the key machines in chemical and petrochemical industries. The most common failure mode in the compressor is valve leakage. Generally, leakage fault is considered to be of little harm to machines. However, it was found that the serious leakage of the valve would cause abnormal bending vibration of the piston rod and accelerate the formation of fatigue cracks. Most researchers utilized the signal of cylinder dynamic pressure, valve temperature or acoustic emission to diagnose valve leakage fault. However, each of these methods has disadvantages. In this paper, a new method is proposed to diagnose valve leakage fault using vibration signal. The main idea is that the severity of valve leakage can be assessed by analyzing energy of the main frequency band during compression process and the delay of discharge valve opening. Firstly, the vibration signal in the time domain is segmented into several angle-domain signals according to the keyphasor signal. Each of the angle-domain signals corresponds to one cylinder working cycle. Then, the time-frequency analysis is conducted with the Gaussian window, and the main energy frequency band and the compression process are determined. Filtering the signal with a bandpass filter based on the main energy frequency band, and the root-mean-square (RMS) of the filtered signal during compression process is calculated in a crank revolution. Besides, the angle of discharge valve opening is detected. Based on the two indicators, the severity of valve leakage can be estimated. To verify the effectiveness of the method, keyphasor of the flywheel, cylinder dynamic pressure and vibration acceleration of valve are acquired on a double-acting oil-free air compressor under different degrees of suction valve leakage. The experimental results and analysis show that the proposed method can well identify the valve leakage fault, even in the case of weak leakage, and is very effective in quantifying the severity of leakage.

Research on the Methods of Detecting and Removing Slide Valve Failure

A Fast Method for Detection of Stiction in Control Valves

Detection Method for Jam Fault in Manipulative Mechanism of Steam Turbine Regulating System

Spectral Method for Detection of Stiction in Control Valves

EXTENDED DISTURBANCE OBSERVER-BASED SLIDING MODE FAULT-TOLERANT CONTROL FOR THE DUAL-VALVE HYDRAULIC SERVO SYSTEM WITH REDUCED-ORDER MODEL

A Study on the Electro-hydraulic Control Systems Based on the New Type Valve for Steam Turbines Fast Valving

Data Characterization for Automatic Selection of Valve Stiction Detection Algorithms.

Analysis and Diagnosis on Internal Leakage in Electro-Hydraulic Quick-Control Regulating System of Steam Turbine

A Fault Detection Method for a Practical Electro-Hydraulic Variable-Displacement Pump with Unknown Swashplate Moment.

Experimental and Modeling Investigation on Dynamic Response of Sticky Control Valves

Research on Adaptive Damper Based on Cone-Slide Valve Combination Regulation Principle

The research of the jam fault features and diagnostic methods of the slide valve oil motive based on DEH data

Three-dimensional computational fluid dynamics simulation of valve-induced water hammer

A Vibration-Based Measurement Method for Dynamic Characteristic of Solenoid Switching Valve

Experimental investigation of the fault diagnosis of typical faults in reciprocating compressor valves

Research on the Clamping Force of Hydraulic Slide Valve

Research on the Diagnosis Method of Reciprocating Compressor Valve Leakage Fault With Vibration Signal

Experiment on Fault Diagnosis of Air Compressor Ring Valve Leakage Using Acoustic Emission

Hydraulic Valve Fault Diagnosis Based on EEWT and POA-KELM

A Non-Intrusive on Line Detection Device Based Wireless Network Electromagnetic Valve

Fault diagnosis of reciprocating compressor valve with the method integrating acoustic emission signal and simulated valve motion