Abstract:A pair of SAR images acquired from different positions can be used to generate digital elevation model (DEM). Two techniques exploiting this characteristic have been introduced: stereo SAR and interferometric SAR. They permit to recover the third dimension (topography) and, at the same time, to identify the absolute position (geolocation) of pixels included in the imaged area, thus allowing the generation of DEMs. In this paper, StereoSAR and InSAR combined adjustment model are constructed, and unify DEM extraction from InSAR and StereoSAR into the same coordinate system, and then improve three dimensional positioning accuracy of the target. We assume that there are four images 1, 2, 3 and 4. One pair of SAR images 1,2 meet the required conditions for InSAR technology, while the other pair of SAR images 3,4 can form stereo image pairs. The phase model is based on InSAR rigorous imaging geometric model. The master image 1 and the slave image 2 will be used in InSAR processing, but the slave image 2 is only used in the course of establishment, and the pixels of the slave image 2 are relevant to the corresponding pixels of the master image 1 through image coregistration coefficient, and it calculates the corresponding phase. It doesn't require the slave image in the construction of the phase model. In Range-Doppler (RD) model, the range equation and Doppler equation are a function of target geolocation, while in the phase equation, the phase is also a function of target geolocation. We exploit combined adjustment model to deviation of target geolocation, thus the problem of target solution is changed to solve three unkonwns through seven equations. The model was tested for DEM extraction under spaceborne InSAR and StereoSAR data and compared with InSAR and StereoSAR methods respectively. The results showed that the model delivered a better performance on experimental imagery and can be used for DEM extraction applications.

A Novel DEM Reconstruction Strategy Based on Multi-Frequency InSAR in Highly Sloped Terrain.

A New DEM Reconstruction Method Based on an Accurate Flattening Algorithm in Interferometric SAR

Elevation reconstruction combining sar intensity and interferometric phase data

A Novel Height Reconstruction Approach Based on MLE Using Multi-frequency InSAR Data.

Height reconstruction using multi-frequency InSAR data based on weighted multigrid phase-unwrapping

Height Reconstruction in Highly Sloped Area Using Multi-frequency InSAR Data

Reconstruction Of Insar Dem Facilitated By Orbit Data And Srtm Data

Using Range Split-Spectrum Interferometry to Reduce Phase Unwrapping Errors for InSAR-Derived DEM in Large Gradient Region

The Facilitation of SRTM DEM-derived Interferogram to Accurate DEM Reconstruction

Terrain Topographic Inversion Using Single-Passpolarimetric SAR Image Data

A High Resolution InSAR Topographic Height Reconstruction Algorithm in Rugged Terrain Based on SRTM DEM

Combined DEM Extration Method from StereoSAR and InSAR

Application of SRTM DEM to phase unwrapping problem in InSAR data processing

Multi-Pass SAR Interferometry for 3D Reconstruction of Complex Mountainous Areas Based on Robust Low Rank Tensor Decomposition.

Digital elevation model generation using multibaseline advanced land observing satellite/phased array type L-band synthetic aperture radar imagery

Sar clinometry-and interferometry-derived dem reconstruction

Underlying Topography Estimation over Forest Using Maximum a Posteriori Inversion with Spaceborne Polarimetric SAR Interferometry

A Multi-Baseline Algorithm with Sparsely-Distributed Permanent Scatterers to Unwrap InSAR Phase in Rugged Terrain.

Millimeter-wave Interferometric Synthetic Aperture Radar Data Imaging Based on Terrain Surface Projection

Exploitation of SRTM DEM in InSAR data processing and its application to phase unwrapping

Error Analysis and 3D Reconstruction Using Airborne Array InSAR Images