Abstract:Foam stability is adversely affected by the drainage process in the liquid film, which has been a great challenge for CO 2 foam flooding in applications. The Gibbs-Marangoni effect, which is induced by the interfacial tension (IFT) gradient, provides a resisting force to the thinning of liquid films in foams under disturbance. Surfactants with higher interfacial elasticity enable rapid recovery to the equilibrium state, thereby improving the stability of the CO 2 foam film. However, there is a lack of mechanistic studies aimed at elucidating the correlation between the interfacial elasticity of surfactant monolayers and the molecular structure of surfactants. In this paper, molecular dynamics simulations were employed to investigate the impact of the headgroups and linking groups of sodium polyoxyethylene alkyl ether sulfate (AES), sodium dodecylbenzene sulfonate (SDBS), sodium dodecyl sulfate (SDS), sodium dodecyl sulfonate (SDSn), and sodium laurate (SLA) surfactants on the interfacial morphology, monolayer properties, and surfactant behaviors at the CO 2 –water interface under reservoir conditions. The results show that the capacity to enhance CO 2 foam stability follows the order AES > SDS > SDSn > SDBS > SLA, which is in good agreement with the available experiments. AES monolayers can reach the lowest IFT (∼0.2 mN/m) and the highest interfacial elasticity (30.4 mN/m). We show that the ethylene oxide groups (EO chains) can strongly interact with water molecules via hydrogen bonding and have affinity interactions with CO 2 molecules, which is beneficial to the hydrophilic-CO 2 -philic balance (HCB). SDS monolayers show the second-lowest IFT (3.1 mN/m) and second-highest interfacial elasticity (26.0 mN/m). The linking oxygen atom in SDS facilitates bond rotation and is favorable to film stability. The phenyl group makes SDBS molecules too rigid and has poor HCB, leading to low stability with high IFT (16.0 mN/m) and low interfacial elasticity (13.1 mN/m). SLA has the highest IFT (22.1 mN/m) and lowest interfacial elasticity (6.3 mN/m), and also presents strong aggregation behaviors at the interface owing to interactions between the carboxyl groups. The simulation method and the microscopic insights delivered here are of great significance in screening surfactants to improve CO 2 foam performance in oilfields.

Surface Dilational Rheology, Foam, and Core Flow Properties of Alpha Olefin Sulfonate

Preparation and rheological properties of a stable aqueous foam system

Interfacial properties and foam performance of alpha olefin sulfonate and CO2 switchable aminopropyl methyl siloxane surfactant mixtures

Influence of Alkyl Chain Length of Alpha Olefin Sulfonates on Surface and Interfacial Properties

Bulk Foam Stability and Rheological Behavior of Aqueous Foams Prepared by Clay Particles and Alpha Olefin Sulfonate

Molecular Dynamics Study on Performance of Olefin Sulfonate at the Decane–Water Interface: Effect of Molecular Architecture

Performance Comparison Between Internal Olefin Sulfonates and Alpha Olefin Sulfonates

Effect of Alkyl Tail Length of Alpha Olefin Sulfonates on Foam Properties

Research on foaming agents for gas flooding in medium-temperature and high-salinity clastic reservoirs

Evaluation of the interfacial elasticity of surfactant monolayer at the CO 2 –water interface by molecular dynamics simulation: Screening surfactants to enhance the CO 2 foam stability

Influence of Hydrocarbon Chain Branching on Foam Properties of Olefin Sulfonate with FoamScan

Static and dynamic foam/oil interactions: Potential of CO2-philic surfactants as mobility control agents

Experimental and DFT Studies on Foam Performances of Lauryl Ether Sulfate-Based Anionic Surface Active Ionic Liquids

Ethanol enhanced anionic surfactant solubility in CO2 and CO2 foam stability: MD simulation and experimental investigations

Investigation of the Stability Mechanism of Stimulus-Responsive Wormlike Micelle-CO2 Foams in the Oil Phase

Experimental Investigation of Foam Flooding Using Anionic and Nonionic Surfactants: A Screening Scenario to Assess the Effects of Salinity and pH on Foam Stability and Foam Height

Gas-liquid surface characterization and liquid film thinning of Non-Aqueous foam

Effect of Hydroxyl Group on Foam Features of Hydroxyl-Based Anionic Ionic Liquid Surfactant: Experimental and Theoretical Studies

An experimental study of foam-oil interactions for nonionic-based binary surfactant systems under high salinity conditions

Experimental studies and computational exploration on an exceptionally salt/condensate resistant gas well foaming mixture compromising amino-betaine-ammonium surfactants and dodecanol

Oil Detachment Mechanism in Natural Surfactant Flooding from Silica Surface: Molecular Dynamics Simulation