Abstract:Focusing on the bending wave characteristic of plate-shell structures, this paper derives the complex band curve of piezoelectric phononic crystal based on the equilibrium differential equation in the plane stress state using COMSOL PDE 6.2. To ascertain the computational model's accuracy, the computed complex band curve is then cross-validated against real band curves obtained through coupling simulations. Utilizing this model, this paper investigates the impact of structural and electrical parameters on the bandgap range and the attenuation coefficient in the bandgap. Results indicate that the larger surface areas of the piezoelectric sheet correspond to lower center bands in the bandgap, while increased thickness widens the attenuation coefficient range with increased peak values. Furthermore, the influence of inductance on the bandgap conforms to the variation law of the electrical LC resonance frequency, and increased resistance widens the attenuation coefficient range albeit with decreased peak values. The incorporation of negative capacitance significantly expands the low-frequency bandgap range. Visualized through vibration transfer simulations, the vibration-damping ability of the piezoelectric phononic crystal is demonstrated. Experimentally, this paper finds that two propagation modes of bending waves (symmetric and anti-symmetric) result in variable voltage amplitudes, and the average vibration of the system decreases by 4-5 dB within the range of 1710-1990 Hz. The comparison between experimental and model-generated data confirms the accuracy of the attenuation coefficient calculation model. This convergence between experimental and computational results emphasizes the validity and usefulness of the proposed model, and this paper provides theoretical support for the application of piezoelectric phononic crystals in the field of plate-shell vibration reduction.

Folding Beam-Type Piezoelectric Phononic Crystal with Low-Frequency and Broad Band Gap

Locally Resonant Band Gaps in Flexural Vibrations of A Timoshenko Beam with Periodically Attached Multioscillators

Defect Mode-Induced Unidirectional Flexural Wave Transmission Using Prismatic Beams with Concentrated Gradient Masses

Low-Frequency Bandgap Characterization of a Locally Resonant Pentagonal Phononic Crystal Beam Structure

A locally resonant phononic crystal structure with low-frequency broad bandgap

Bandgap Calculation and Experimental Analysis of Piezoelectric Phononic Crystals Based on Partial Differential Equations

Flexural vibration band gaps in a phononic crystal beam containing rotational resonators

Tuning of Band Gaps for a Two-Dimensional Piezoelectric Phononic Crystal with a Rectangular Lattice

Flexural Vibration Band Gaps in a Double-Side Phononic Crystal Plate

Ultralow Frequency Acoustic Bandgap And Vibration Energy Recovery In Tetragonal Folding Beam Phononic Crystal

Study on Elastic Wave Band Gap Excitation of Phononic Crystal at Ultra-Low Filling Rate

On‐Chip Tightly Confined Guiding and Splitting of Surface Acoustic Waves Using Line Defects in Phononic Crystals

Analysis of Flexural and Torsional Vibration Band Gaps in Phononic Crystal Beam

Designing a Broad Locally-Resonant Bandgap in a Phononic Crystals

Bandgap Structures Of Sh-Wave In A One-Dimensional Phononic Crystal With Viscoelastic Interfaces

Multilayer-split-tube Resonators with Low-Frequency Band Gaps in Phononic Crystals

Ultrawide band gaps in beams with double-leaf acoustic black hole indentations

Tunable Bandgaps in Soft Phononic Plates with Spring-Mass-like Resonators

Wave band gaps in two-dimensional piezoelectric/piezomagnetic phononic crystals

Dynamic phononic crystals with spatially and temporally modulated circuit networks

Band gaps in phononic crystals: Generation mechanisms and interaction effects