Abstract:This Letter proposes an approach to develop a spoof surface plasmon polariton (SSPP) transmission line (TL) by loading short-circuited (SC) shunt stubs. Lower out-of-band rejections can be flexibly controlled without affecting the upper cutoff frequency by independently modifying the stubs. Dispersion analysis of the SSPP unit is realized by theoretical calculation and circuit simulation to predict the upper cutoff frequency of the proposed SSPP TL simultaneously. Also, parametric sweeping of the SC shunt stubs is performed based on circuit simulation to investigate their impacts on the lower and upper out-of-band rejections of the proposed SSPP TL. In addition, electric field distributions of different types of TLs are simulated and compared to study the transmission characteristics of the proposed SSPP TL. The lower cutoff frequency can be flexibly tuned in a wide range, from 1.2 to 2.1 GHz, in the simulations. The measured 3-dB fractional bandwidth is about 128.1%, covering a range from 1.19 to 5.43 GHz. The numerical and experimental results are compatible, which verifies the feasibility of the proposed approach. This approach can offer more convenience and flexibility for controlling the rejections of the SSPP by introducing up to four tuning parameters. More importantly, the proposed SSPP TL avoids using the substrate integrated waveguide (SIW) technique, which shows the potential to decrease the transverse width ( 0.44 λ g ), especially at lower frequencies (e.g., 1.2 GHz), and to reduce the complexity in designing the high-efficiency transition. This work paves the way for the development of novel SSPP-based microwave devices.

Shunt-Stub and Stepped-Impedance Broadband Reflective Phasers

Design of Broadband Low-Pass Reflective Phasers

Design of dispersion‐reconfigurable phaser using stepped‐impedance line

Broadband Nonreciprocal Spoof Plasmonic Phase Shifter Based on Transverse Faraday Effects

An Ultra Broadband Passive Vector Modulator Phase Shifter

Compact Reflection-Type Phaser Using Quarter-Wavelength Transmission Line Resonators

Synthesis of Narrowband Reflection-Type Phasers With Arbitrary Prescribed Group Delay

Design of Dispersion-Reconfigurable Phaser Using PIN-Diode Loaded Stepped-Impedance Line

Parasitic Effect Suppression with Resonance Cancelation for Broadband Absorber/Reflector

Planar Reflective Phaser and Synthesis for Radio Analog Signal Processing (R-ASP)

Non-uniform C-section Phasers for Enhanced Design Flexibility in Radio Analog Signal Processing

A New Broadband Differential Phase Shifter Fabricated Using a Novel CRLH Structure

Enhanced Bandwidth and Diversity in Real-Time Analog Signal Processing (R-ASP) Using Nonuniform C-Section Phasers

Broadband and Wide Range Tunable Phase Shifter Based on Composite Right/left Handed Transmission Line

A Broadband Digital Phase Shifter Using Phase-Slope Tuning Properties of Microstrip to Slotline Transition and Microstrip-Loaded Slotline Structure

Generalized Coupled-Line All-Pass Phasers

Short-circuited Stub-Loaded Spoof Surface Plasmon Polariton Transmission Lines with Flexibly Controllable Lower Out-of-band Rejections

Design Of A Dispersion-Switchable Phaser For Chirping Modulation

Design of Ultraflat Phase Shifters Using Multiple Quarter-Wavelength Short-Ended Stubs

High Selectivity Wideband Bandpass Filter Based on Stepped Impedance Open Stubs Loaded Ring Resonator

Reflection Phase Shifter Topology With 180° Tuning Range Using Impedance Transforming Coupler and Series Resonant Load for K-Band Phased Arrays