Abstract:Unraveling the microstructural heterogeneity is an important issue to understand the physical and mechanical properties of metallic glasses. Structural relaxation below the glass transition temperature Tg and cold rolling at ambient temperature are effective ways to tune the state within the potential energy landscape of metallic glasses, modifying the microstructural heterogeneity. With the help of nanoindentation technique, by scrutinizing the local reduced modulus and hardness of a typical Zr50Cu40Al10 metallic glasses in different energy states (from structural relaxed state to rejuvenated state), we demonstrate that the enhancement of microstructural heterogeneity plays an important role in tailoring the mechanical behavior. The internal friction coefficient is obtained by fitting the experimental load-displacement curves with finite element simulation. It is found that internal friction coefficient decreases with the increase of concentration of flow defects. The stress exponent obtained from the creep stage shows a strong dependence on the structural state of metallic glasses. Effects of structural relaxation and rejuvenation on the structural state are rationalized in terms of the relative flow defects concentration. Finally, the statistics of discrete displacement bursts during the deformation process were probed. We find that the displacement bursts behavior is sensitive to the structural energy state (microstructural heterogeneity). The displacement bursts phenomenon changes from obvious (relaxed state) to unapparent behaviors (rejuvenated state). By given a physical schematic, the correlation between the displacement bursts size and the shear band size in the local plastic zones is well established, which will lead to a deeper understanding of the rejuvenation-induced plasticity of metallic glasses.

Serration Behaviours in Metallic Glasses with Different Plasticity

Intrinsic Versus Extrinsic Effects on Serrated Flow of Bulk Metallic Glasses

Effect of Pre-Existing Shear Bands on Mechanical Properties and Serration Behaviors in Bulk Metallic Glasses

Atomic-scale Heterogeneity in Large-Plasticity Cu-doped Metallic Glasses

Serration Behavior of A Zr-Based Metallic Glass under Different Constrained Loading Conditions

Rate-dependent Plastic Deformation of TiZrHfCuNiBe High Entropy Bulk Metallic Glass

Unraveling the microstructural heterogeneity and plasticity of Zr<sub>50</sub>Cu<sub>40</sub>Al<sub>10</sub> bulk metallic glass by nanoindentation

Structural Heterogeneity Originated Plasticity in Zr–Cu–Al Bulk Metallic Glasses

Bulk Metallic Glasses: “defects” Determines Performance

Serration and Shear Avalanches in a ZrCu Based Bulk Metallic Glass Composite in Different Loading Methods

Effect of Structural Heterogeneity on Serrated Flow Behavior of Zr-based Metallic Glass

The evolution of local mechanical properties of bulk metallic glasses caused by structural inhomogeneity

Study of Serrated Flow and Plastic Deformation in Metallic Glasses Through Instrumented Indentation

On the fractal analysis of the serration behavior of a bulk metallic glass composite

Aspect Ratio Effects on the Serrated Flow Dynamic of TiZrHfCuNiBe High Entropy Metallic Glass

Aspect ratio effects on the serration dynamics of a Zr-based bulk metallic glass

Size Dependent Hidden Serration Behaviors of Shear Banding in Metallic Glass Thin Films

Dependence of ductile-brittle transition related with serrated flow on viscosity dominated by glass forming ability in ZrxTi65-xBe27.5Cu7.5 metallic glasses

Relationship between structural heterogeneity and serrated flow in nanoscale phase separated Zr-Cu-Fe-Al bulk metallic glasses

Effect of shear bands initiated in the pre-yield region on the deformation behaviour of Zr-based metallic glasses

Shear Transformation Zones and Serrated Flow Dynamics of Metallic Glasses Revealed by Nanoindentation