Abstract:The presence of nonaqueous phase liquid (NAPL) in the subsurface presents significant challenges for soil and groundwater remediation. In particular, heavy crude oil, coal tar and/or bitumen present unique difficulties for removal and cleanup due to associated high viscosities, low aqueous solubilities, and limited mobility extraction potential. Although surfactant-enhanced aquifer remediation (SEAR) techniques have shown some promise for source removal, overall remediation (mobilization) performance will depend significantly on interfacial effects between the fluid and solid phases. A pore-scale study, implementing synchrotron X-ray microtomography (SXM), was conducted to understand and quantify the trapping and mobilization mechanisms and in-situ emulsification processes of heavy crude oil distributed within increasing complexity (i.e. physical heterogeneity) unconsolidated sands during surfactant flushing events. Pore-scale imaging analyses were conducted to quantify the changes in oil blob morphology before and after surfactant flushing events to assess the primary factors controlling the recovery. Results showed relatively low (10%) net recovery from the homogeneous sand after 5 pore volumes (PVs) of surfactant flushing and may be, in part, due to the more connected ganglia (i.e. single continuous) oil-phase. Such a condition may have limited the surfactant/oil contact resulting in relatively low interfacial activity and correspondingly inefficient oil mobilization and recovery. Negligible net oil recovery was achieved from the mildly-heterogeneous-sand and is likely due to the lower associated permeability of this particular porous medium. Furthermore, the oil-phase distribution within this medium primarily consisted of small disconnected blobs more readily exposed (in contact with) the surfactant solution. For the highly-heterogeneous-sand experiments, an average of 20% heavy-oil recovery resulted after each flushing event (total of ~37% after 5 PVs) and was attributed to more efficient reduction of interfacial tension associated with the increased surfactant-oil contact. The associated higher pH sand/fine‑carbonate system may have aided in maintaining a water-wet porous medium, a condition more conducive to higher oil recovery and displacement efficiency.

Effects of surfactant injection position on the airflow pattern and contaminant removal efficiency of surfactant-enhanced air sparging

Laboratory Characterization of Surfactant-Enhanced Air Sparging Effectiveness on VOC-Contaminated Soil with Low Permeability

Experimental Study on the Screening of High-Efficiency Flushing Agents and the Optimum Injection Modes Adaptable for Landfill Leachate-Contaminated Soil

Laboratory Evaluation of the Use of Solvent Extraction for Separation of Hydrophobic Organic Contaminants from Surfactant Solutions During Surfactant-Enhanced Aquifer Remediation

Effect of Chemical Agents on the Diffusion Behavior of Oxygen in Groundwater Under Combined Remediation Technique of Air Sparging and Soil Flushing

Test for the effects of three surfactants on the penetration ability of the calcium chloride and water glass solutions in dust

Air sparging remediation of VOCs contaminated low-permeability soil based on pressure gradient control

3D numerical simulation of air sparging remediation process

Centrifugal study of zone of influence during air-sparging.

Analysis of Facilitated Air Intrusion during Surfactant-enhanced Air Sparging Using Surface Tension-reducing Chemicals: Surfactants and Alcohols

Mass transfer enhancement of air sparging on VOCs contaminated low-permeability soil by establishing pressure gradient

Physical Modeling of Air Flow During Air Sparging Remediation

Surfactant-enhanced remediation of oil-contaminated soil and groundwater: A review

The Effects of Spill Pressure on the Migration and Remediation of Dense Non-Aqueous Phase Liquids in Homogeneous and Heterogeneous Aquifers

Solvent Extraction for Separating Micellar-Solubilized Contaminants and Anionic Surfactants

Physical Modeling of Air-Sparging Technique for Groundwater Remediation

Interaction quantitative modeling of mixed surfactants for synergistic solubilization by resonance light scattering

Centrifuge Modeling and Numerical Simulation of Air Sparging Process

Enhanced Remedial Amendment Delivery to Subsurface Using Shear Thinning Fluid and Aqueous Foam

Influence of surfactant sorption on the removal of phenanthrene from contaminated soils.

A pore-scale investigation of heavy crude oil trapping and removal during surfactant-enhanced remediation