Abstract:Surfactants have been widely used in agriculture mainly as adjuvants to aid foliar pesticides to stay on target areas and as wetting agents to counteract the deleterious impacts of soil hydrophobicity. The latter has gained increasing attention among scientists over decades. Many natural and urban hydrophobic soil surfaces (i.e post-fire forest land and golf greens with dry patches respectively) after surfactant application has observed to have improved hydrological behaviors such as enhanced infiltration rate, more evenly-distributed water content, thus resulting in higher water use efficiency, better performances of amenity surfaces and higher crop yield. In general, a surfactant can be classified as cationic, anionic or nonionic according to the charge of its polar group. Commonly, with anionic and nonionic surfactants are employed by either directly mixing with the soil or incorporated into the irrigating. Regardless of the application mode, the occurrence of surfactant adsorption onto soil particles after wetting/drying cycles is highly expected, which, in fact, has already shown in some studies to change the hydraulic properties of the soil, oppositely to initial expectation. Capillary rise, for example, was found to decrease in sand treated with laundry derived detergent. In addition, sub-critical hydrophobicity was observed in sands pre-saturated with greywater derived surfactants after some cycles of wetting and drying. Insights from these studies implied that surfactant application to hydrophilic soils may eventually induce temporal hydrophobic nature. In this regard, the main objective of this study was to quantify the sorptivity and imbibition rate of air-dry soil subjected to wetting and drying with surfactants. Specifically, we employed three types of surfactants: (i) anionic (SDS), (ii) cationic (CTAB) and (iii) nonionic (TX-100). Quartz sand was sieved through 0.5mm sieve and wet-packed into columns (I.D.=3.5cm and L=6cm) with surfactant concentrations above and below the CMC (Critical Micelle Concentration) and then oven-dried at 65oC for 24h. We have repeated this procedure to obtain soil samples undergoing 1 to 5 wetting/drying cycles. The soil samples were subjected to imbibition using the capillary rise method with water and ethanol, from which the initial sorptivity, imbibition rate and contact angle (CA) were calculated. The Wilhelmy plate method (WPM) and sessile drop method (SDM) was also used to measure the CA. The results showed that following one application of the three surfactants, the sorptivity was reduced relative to the control. Further reduction observed only for TX-100 and CTAB soil samples. The CA values obtained from the WPM and SDM implied that sub-critical hydrophobicity was induced only for the CTAB-treated, implying that water imbibition in the SDS and TX-100 treated soil in manly governed by the reduced surface tension rather than in the induced hydrophobicity (i.e. CA). Further discussion on the governing mechanism of wetting in surfactant-containing soils will be presented next to the results.&#160;&#160;&#160;&#160;&#160; &#160;&#160;&#160;&#160;&#160;&#160;&#160;

Test for the effects of three surfactants on the penetration ability of the calcium chloride and water glass solutions in dust

Effect of calcium chloride solution on penetration ability by adding sodium succinate

Test of Chlorides Mixed with Cao, Mgo, and Sodium Silicate for Dust Control and Soil Stabilization

Effect of Chemical Agents on the Diffusion Behavior of Oxygen in Groundwater Under Combined Remediation Technique of Air Sparging and Soil Flushing

Coupling of Anionic Wetting Agents to Dust of Sulfide Ores by Dropping Liquid Method

Jointed Effects of Inorganic Salts and Sodium Dodecyibenzene Sulfonate (SDBS) on Sorption and Adsorption of Phenanthrene in Loess Soils

An Experimental Study on Wetting of Coal Dust by Surfactant Solution

Development of cementitious capillary crystalline waterproofing agents and durability study of concrete in the presence of chloride with sulfate in aqueous environment

Experimental Study on Dust Suppression Performance of Surfactant

Experimental Study on the Screening of High-Efficiency Flushing Agents and the Optimum Injection Modes Adaptable for Landfill Leachate-Contaminated Soil

Measurements of Surfactant Adsorption on Sandstone in the Presence of Deep Eutectic Solvents

Experimental Investigation of Coal Dust Wetting Ability of Anionic Surfactants with Different Structures

Experimental Analysis on Water Penetration Resistance and Micro Properties of Concrete: Effect of Supplementary Cementitious Materials, Seawater, Sea-Sand and Water-Binder Ratio

Surface physical properties and its effects on the wetting behaviors of respirable coal mine dust

The influence of surfactant on the wettability of coal dust and dust reduction efficiency

Study on the mechanical mechanism of dynamic wetting of sodium dodecyl sulfonate solutions containing inorganic salt additives

Experimental Study for Influence of Surfactants Chemical Microstructures on Wetting Effect about Coal Dust in Tongchuan Mining Area

Study on wetting mechanism of nonionic silicone surfactant on coal dust

Preparation of Lignite Dust Suppressant by Compound Surfactants and Effect of Inorganic Salt on Dust Suppressant

Experimental and molecular dynamics simulation study of the effect of different surfactants on the wettability of low-rank coal

Sorptivity and water imbibition into air-dry surfactant-containing soil