Abstract:Laser powder-bed fusion (L-PBF) is a promising manufacturing process for fabricating metallic parts with tailored architectures. A feedstock powder with good flowability is required to homogeneously deposit the powder on the building substrate and obtain reliable and high-quality L-PBF products. Although the effects of powder morphology and particle size on flowability have been widely investigated, the relationship between powder surface conditions and rheological behaviors is not well established. Therefore, in this study, the surface conditions of Ti-6Al-4 V alloy powders were intentionally adjusted through conventional heat treatments under different gas atmospheres. The morphology and particle size distribution of the Ti-6Al-4 V powder heat treated at 773 K in air (Air773) and Ar (Ar773) atmospheres remained unchanged compared to those of the untreated powder. However, the quantity of surface oxides on the Air773 powder increased, enhancing the decoration of surface hydroxyl groups, as illustrated by water wettability tests. By contrast, the oxide layer of the Ar773 powder decomposed and dissolved into the matrix, resulting in the generation of fresh metallic surfaces. Consequently, the flowability of the Air773 powder increased, whereas that of the Ar773 powder tended to decrease, thereby deteriorating the quality of powder beds during the recoating process. The results prove that the cohesive strength of Ti-6Al-4 V powder is more strongly determined by metallic Ti-Ti interactions than by hydrogen bonds. Thus, the effective approach for adjusting the powder surface conditions presented in this study offers new insights into the potential for economically developing high-performance Ti alloy components by controlling the powder properties and L-PBF process.

Effects of plasma rotating electrode process parameters on the particle size distribution and microstructure of Ti-6Al-4 V alloy powder

Effects of process parameters and cooling gas on powder formation during the plasma rotating electrode process

Effect of Preparation Process on the Microstructure and Characteristics of TiAl Pre-Alloyed Powder Fabricated by Plasma Rotating Electrode Process

Centrifugal granulation behavior in metallic powder fabrication by plasma rotating electrode process

Titanium-Tantalum Alloy Powder Produced by the Plasma Rotating Electrode Process (PREP)

Microstructural Characterization and Properties of Ti-28Ta At.% Powders Produced by Plasma Rotating Electrode Process

Characterization of pre-alloyed NiTi powders produced by electrode induction-melting inert gas atomization for additive manufacturing

Non-equilibrium solidification behavior associated with powder characteristics during electron beam additive manufacturing

Effects of Powder Preheating in Electron Beam Selective Melting Process

Residual oxygen content and powder recycling: effects on microstructure and mechanical properties of additively manufactured Ti-6Al-4V parts

Controlling factors determining flowability of powders for additive manufacturing: A combined experimental and simulation study

Influence of powder characteristics on microstructure and mechanical properties of Inconel 718 superalloy manufactured by direct energy deposition

Influence of Different Powder Conditioning Strategies on Metal Binder Jetting with Ti-6Al-4V

Numerical simulation of powder effect on solidification in directed energy deposition additive manufacturing

Non-Equilibrium Solidification Behavior With Solute Trapping Associated With Powder Characteristics During Electron Beam Additive Manufacturing

Effects of Powder Surface Conditions on the Rheological Behavior of Ti–6Al–4 V Alloy Powders for Additive Manufacturing

Morphology and particle analysis of the Ni3Al-based spherical powders manufactured by supreme-speed plasma rotating electrode process

The effects of powder reuse on the mechanical response of electron beam additively manufactured Ti6Al4V parts

Raking process for Powder Bed Fusion of Ti-6Al-4V alloy Powder Analyzed by Discrete Element Method

Dynamics of the laser–powder interaction in the Ti6Al4V powder feeding process of laser-directed energy deposition additive manufacturing

Effect of Particle Size Distribution on the Printing Quality and Tensile Properties of Ti-6Al-4V Alloy Produced by LPBF Process