Abstract:Micro thin-walled structure of aluminum alloy LF 21 has a strong ability to reflect electromagnetic waves and is widely used in waveguide radar antenna. Micro-milling technology is a potentially effective technique for machining micro thin-walled structure of LF 21. However, LF 21 has the characteristics of low strength and hardness and high plasticity and is prone to plastic flow under cutting force, resulting in extrusion, accumulation, and other defects and easy to produce burrs. Then the surface roughness and surface residual stress are difficult to guarantee. To ensure the machining quality of micro-milling thin-walled LF 21, a 3D simulation model of micro-milling LF 21 process is established based on Abaqus to output residual stress. The validity of the residual stress output is verified by experimental results. Four-factor and three-level orthogonal simulation experiments are conducted, and a prediction model of residual stress is established based on the simulation results. Based on the response surface method (RSM), four-factor and five-level center composite design (CCD) experiments are conducted to establish a surface roughness prediction model and a top burr size prediction model. The validity of the built prediction models is verified by experiments. Multi-objective optimization (the minimum surface roughness, the minimum top burr size, and the maximum surface compressive residual stress) is transformed into single-objective optimization by using the analytic hierarchy process (AHP)-entropy weight method. Genetic algorithm (GA) is used to solve the above optimization problem, and the optimal machining parameters of micro-milling LF 21 are achieved. The optimal micro-milling parameters are as follows: the spindle speed n is 62,000 r/min, the axial depth of cut ap is 70 μm, the radial depth of cut ae is 65 μm, and the feed per tooth fz is 0.95 μm/z.

Maximum stable milling area and optimization of cutting parameters

Machining Parameter Optimization of Milling Process Based on Uniform Design

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Analysis and Optimization of Parameters of Machine Tool in Structure Design Based on the Cutting Dynamics with Uncertainty

Stability-Based Selection of Cutting Parameters to Increase Material Removal Rate in High-Speed Machining Process

The optimization of cutting parameters for surface roughness in high speed milling based on Taguchi method

High Efficiency Orientated Milling Parameter Optimization with Tool Wear Monitoring in Roughing Operation

Method to obtain material model parameters used in three dimensional-simulating milling process

Cutting parameter optimization based on force and heat constraint in milling TC4 titanium alloy

The Dynamic Comprehensive Evaluation of the Importance of Cutting Parameters in the Side Milling TC4 Process Using an Integrated End Mill

The Multi-Objective Optimization on Milling Parameters of Ultra-High Strength Steel 30Cr3sinimova

Comprehensive Evaluation Analysis and Optimization Methodology of Tool Geometric Parameters for High Speed Cutting

Prediction of surface roughness and optimization of process parameters for efficient cutting of aluminum alloy

Multi-Constrained Analysis Of Metal Cutting And Its Application

Suppressing the burr of high aspect ratio structure by optimizing the cutting parameters in the micro-milling process

Cutting parameters optimization by fuzzy synthetic evaluation and BP neural network in milling aluminum alloy

Multi-objective optimization of machining parameters in micro-milling LF 21 based on the AHP-entropy weight method

Finite Element Simulation and Analysis of Size Effect in Micro-Milling Process

Optimizing Design of the Cutting Tool in Cutting of Ultra-High Strength Steel Beam Part

Multi-physics analytical modeling of the primary shear zone and milling force prediction