Abstract:The wake effect is one of the main factors affecting the power generation of wind farms. Wake regulation is often used to reduce the wake interference between wind turbines. Accurate assessment of the wake flow of wind turbine is essential to wake regulation. Engineering wake models are widely used for rapid evaluation of the wake at present due to lower computational resource cost. However, the selection of empirical parameters of the wake model has significant influence on the prediction accuracy, especially in the case of yaw. The actuator model based on CFD simulation has less dependence on empirical parameters and higher simulation accuracy. However, the computational cost is too high for wake regulation for large wind farms. This paper proposed an improved wake regulation method that combines the advantages of the actuator line model (ALM) method and the engineering wake mode. The simulation results of the ALM is used to calibrate the empirical parameters of the engineering wake model. The calibrated wake model can be used to optimize the yaw angle of wind turbines during wake regulation. The accuracy of two models is compared using wind tunnel experimental data. The ALM results give better agreement to the experimental data. The Horns Rev wind farm case is used for the coupled method verification. The power generation increase using the engineering wake model is obviously greater than that of the ALM. After calibrating the wake model, the gap between the two power predictions is greatly narrowed, which proves the effectiveness of the proposed method. The proposed coupling method can be used to improve the credibility of the wake regulation with affordable computational cost.

Research onwake effect model of wind farm

Research on Wind Speed Distribution Model of Wind Farm Based on Its Dynamic Space-Time Relation

Equivalent Wind Farm Model Considering Different Wind Speeds and Wake Effects

Study on the wind-farm wake under neutral atmospheric condition

Evaluation of Various Near and Far Wake Models for Wind Power Generation

A novel two-dimensional entrainment wake model for wind turbine wakes

Research on the Power Capture and Wake Characteristics of a Wind Turbine Based on a Modified Actuator Line Model

A data-driven analytical model for wind turbine wakes using machine learning method

Wind Turbine Wake Regulation Method Coupling Actuator Model and Engineering Wake Model

A New Study on the Effect of the Partial Wake Generated in a Wind Farm

Evolution mechanism of wind turbine wake structure in yawed condition by actuator line method and theoretical analysis

Studies on Models and Algorithms of the Power System Probabilistic Production Simulation Integrated with Wind Farm

A review of physical and numerical modeling techniques for horizontal-axis wind turbine wakes

A new Gaussian analytical wake model validated by wind tunnel experiment and LiDAR field measurements under different turbulent flow

Numerical investigation of the average wind speed of a single wind turbine and development of a novel three-dimensional multiple wind turbine wake model

Analytical Modeling of Wind Farms: A New Approach for Power Prediction

Experimental study on the wind-turbine wake meandering inside a scale model wind farm placed in an atmospheric-boundary-layer wind tunnel

Research on Evaluation Method of Wind Farm Wake Energy Efficiency Loss Based on SCADA Data Analysis

On the Importance of Wind Turbine Wake Boundary to Wind Energy and Environmental Impact

Wind Resource Assessment System of Wind Farm based on Particle Wake Model

Numerical simulation of wake interaction between two offset-line model wind turbines based on actuator line model