Abstract:Near-threshold voltage (NTV) operation has the potential to improve the energy efficiency of digital integrated circuits. However, the use of a conservative timing guard band to avoid the timing errors introduces excessive timing margins, thus causing larger energy dissipation in the NTV region. An error-tolerant design based on timing error detection and correction circuits has been shown to be a promising solution to mitigate these issues. This paper presents a light-weight timing error-tolerant flip-flop (ETFF) design. This design detects timing errors using a node transition signal detector with only nine transistors and corrects these errors during the same clock cycle. Moreover, transistor sizing is explored to optimize the trade-off between performance and area overhead. The proposed ETFFs are inserted into a monitored circuit by replacing original flip-flops at timing-monitored points. To further reduce the overhead, we develop a mean-time-to-failure-aware method to select the monitored points by simultaneously considering the critical path coverage and activation rates of flip-flops. The simulation results show that a CNN accelerator using the proposed timing error-tolerant design implemented in the SMIC CMOS 40 nm process can robustly work at 1.1–0.3 V with only 3.5% area overhead. Furthermore, this design reduces the area overhead by 54.68% and improves the energy efficiency by 53.69% at 0.6 V, compared with the Razor flip-flop design. The advantage of the proposed design lies in that it requires smaller circuit overheads and can work reliably in a wider range of supply voltages.

Edsu: Error Detection And Sampling Unified Flip-Flop With Ultra-Low Overhead

Eliminating Timing Errors Through Collaborative Design to Maximize the Throughput

FLC-EDC: A Fast Low-Cost Error Detection and Correction Scheme for AVFS System Based on Flip-Flops Resampling in 28-Nm CMOS

Ultra Low Overhead Error Mask Flip-Flop in Near Threshold Voltage Processor Design

Error Cancellation Flip-Flop Design with Lightweight In-Situ Error Correction

A Timing Failure Tolerance Design with In-Field Simultaneous Error Detection and Correction.

A DFT-Compatible In-Situ Timing Error Detection and Correction Structure Featuring Low Area and Test Overhead

An Energy-Efficient Microprocessor Using Multilevel Error Correction For Timing Error Tolerance

A Light-Weight Energy-Efficient Resilient Circuit for Variation Tolerance

iEDCL: Streamlined, False-Error-Free Error Detection and Correction Scheme in a Near-Threshold Enabled 32-bit Processor

A new error masking flip-flop with one cycle correction penalty

A Wide-Voltage-Range Transition-Detector with In-Situ Timing-Error Detection and Correction Based on Pulsed-Latch Design in 28 Nm CMOS.

Design of Light-Weight Timing Error Detection and Correction Circuits for Energy-Efficient Near-Threshold Voltage Operation

A Low-Cost Error-Tolerant Flip-Flop Against SET and SEU for Dependable Designs

Light-Weight One-Cycle Timing Error Correction Based On Hardware Software Co-Design

A Soft Error Detection and Recovery Flip-Flop for Aggressive Designs with High-Performance

Soft-Edge Error-Detecting Flip-Flop For Lowering Error-Correction-Rate Under Ultra-Low Voltage

An Improved Error Detection and Correction Method for Single Event Upset with Clock Edge

A 0.46V-1.1V Transition-Detector with In-Situ Timing-Error Detection and Correction Based on Pulsed-Latch Design in AES Accelerator.

A Kind of Low-cost Non-intrusive Autonomous Fault Emulation System

Design of Low Power FlipFlop to Reduce Area and Delay using Conditional Pulse Enhancement Method