Abstract:Accuracy of operational data of a power plant is essential for power plant performance monitoring and fault diagnosis. However, due to inevitable occurrence of systematic and measurement errors in the course of obtaining operational data, these errors can only be reduced to a certain level but never be eliminated. In this work, we propose a data reconciliation based approach to reduce the errors of operational data thus enhance the accuracy of the data. The reconciled data can then be used in performance monitoring and fault diagnosis systems to improve their performances. The proposed method is based on more efficient use of redundant data and a first-principle mathematical model of a power plant. Then an optimization process is performed where the weighted least square form of aggregated differences between measured data and their estimated values are minimized. To illustrate the capability of the proposed method, we provide a case study of data reconciliation for feedwater heater heat balance analysis in a 660 MW coal- fired power plant in China. Results show that uncertainty of four key parameters, namely feed water mass flow rate, condensate mass flow rate, deaerator pressure and outlet temperature, can be reduced by 24 %, 30 %, 5 % and 65 %, whilst the uncertainty of other parameters are also reduced to various extent. Moreover, the results also indicate that the proposed approach is effective over a wide range of measured data quality, where quality of some data could be much worse than others and the estimated measurement uncertainties of operational data may not be accurate.

Estimation of exhaust steam enthalpy and steam wetness fraction for steam turbines based on data reconciliation with characteristic constraints.

Data Reconciliation for Steam Turbine On-Line Performance Monitoring

Inequality Constrained Nonlinear Data Reconciliation of a Steam Turbine Power Plant for Enhanced Parameter Estimation

Data Reconciliation for the Overall Thermal System of a Steam Turbine Power Plant

Optimization on Start-up Process of Steam Turbine in Combined Cycle Generating Units

Study on Quick Start-up of Steam Turbine in a Gas-Steam Combined Cycle

Analysis and extension of equivalent enthalpy drops theory

Optimization of Start-up Process in Combined Cycle Steam Turbine of a Power Plant

Gross error detection in steam turbine measurements based on data reconciliation of inequality constraints

TO CALCULATE THE STRENGTH OF TURBINE＇S DIAPHRAGM BY USING FINITE ELEMENT METHOD

Steam Turbine Performance Evaluation Based on Principal Component Analysis and Information Entropy

Improvements on the equivalent enthalpy drop method

A Data Reconciliation Based Approach to Accuracy Enhancement of Operational Data in Power Plants

Correcting and Calculating the Effect on Turbine Power of Exhaust Pressure Variation for Condensing Steam Turbine

Improvements On The Equivalent Enthalpy Drop Method And Its Application In Thermal Economy Diagnosis Of Thermal System Of Steam Turbine

Data Reconciliation of the Thermal System of a Double Reheat Power Plant for Thermal Calculation

A real-time monitoring model for heat consumption rate of steam turbine unit based on unit power

Operation Data Based Modelling and Performance Monitoring of Steam Turbine Regenerative System under Full Working Conditions

Research on Thermodynamic Characteristics of the Saturated Flue Gas Waste Heat Recovery to Reduce Turbine Extraction Steam

Impact of Steam-Equalizing Equipment on Exhaust Steam Pressure of 300 MW Steam Turbine and Economic Analysis

State Estimation For Steam Networks Considering Drainage And Parameter Uncertainties