Abstract:Starting with the initial design stage, the ship resistance constitutes one of the most important hydrodynamic aspects. In order to generate and optimize the body lines plan, the ship resistance performance must be considered. In this case, both numerical and experimental methods must be applied to obtain the minimum ship resistance controlled by the speed domain. In the last years, numerical studies based on the Computational Fluid Dynamic (CFD) were implemented in the initial ship design stage in order to analyse the free-surface flow and to predict the ship resistance. The numerical optimization process of the hull forms must be validated by means of the experimental model tests in the specific towing tanks. The constant evolution of the numerical and experimental methodologies can be noted. As a consequence, the accuracy level of the ship resistance prediction is increased; though, difficult numerical problems can occur in case of the unconventional hull forms. Taking into account this aspect, a complex numerical and experimental investigation of the ship resistance problem and free-surface topology was performed in the case of the DTMB surface combatant. A parallel numerical simulation was carried out by using the viscous flow solver ISIS–CFD of the software FINE TM /Marine provided by NUMECA. The solver is based on the finite volume method to build the spatial discretization of the transport equation to resolve the Reynolds-Averaged Navier Stokes (RANS) equation. Closure to turbulence is achieved by making use of the k-ω SST model, while the free-surface is captured through an air-water interface based on the Volume of Fluid (VOF) method. For the validation purpose, the tank conditions are reintroduced in the numerical model to account for any banking effect, especially for the high speed cases. Experimental model tests were performed in accordance with the ITTC standard procedures, while the extrapolation process to the full-scale was obtained by using an in-house code, based on the ITTC 57 method. The experimental results are compared through with some internationally recognized towing tank experiments that have been performed for a similar ship model, showing a good agreement. Also, the numerical results are validated against the experimental data and showed to be within a satisfactory congruence.

Resistance Analysis of Rescue Boat in Calm Water Condition

Performance of Rescue Boat Operation when Operated in Waves

Boat Trial Validation and Resistance Prediction of a 36-Foot Hydrofoil Catamarans Using CFD

Study on the Resistance of a Large Pure Car Truck Carrier with Bulbous Bow and Transom Stern

CFD Analysis into the Resistance Characteristics of Remotely Operated Vehicles when Submerges Under Water and Sails on the Surface

CALCULATION AND OPTIMIZATION OF FORCE AND POWER ON AUTONOMOUS SURFACE VEHICLE (ASV) AS MEANS OF MARINE ACCIDENT RESCUE

Resistance Calculation and Motion Simulation for Deep Sea Open-Framed Remotely Operated Vehicle Based on Hydrodynamics Test

Performance evaluation on the designed v-shaped monohull ship models

Numerical and Experimental Investigation on the Free-surface Flow and Total Resistance of the DTMB Surface Combatant

Investigation of the effectiveness of a stern foil on a patrol boat by experiment and simulation

Comparative Investigation of an Automated Oceanic Wave Surface Glider Robot Influence on Resistance Prediction Using CFD Method

Full-scale CFD simulations for the determination of ship resistance as a rational, alternative method to towing tank experiments

STUDI PERANCANGAN KAPAL FERRY RO-RO MODEL KATAMARAN DI PERAIRAN DANAU TOBA

Finite Element Analysis (FEA) on Autonomous Unmanned Surface Vehicle Feeder Boat subjected to Static Loads

Investigation of An Inverted Bow on Frigate Hull Resistance

A Computational Fluid Dynamics Method for Resistance Prediction of the Floating Hull of Wave Glider

Numerical Analysis for Resistance Calculations of NPL As a Floating Hull for Wave Glider

Dataset of the catamaran floater in towing tank test with fix moment reference point

Kinematic response analysis of a three-dimensional lifeboat water entry based on smoothed particle hydrodynamics

CFD-based Multi-Objective Optimisation of S60 Catamaran Considering Demihull Shape and Separation

Investigation on Calm Water Resistance of Wind Turbine Installation Vessels with a Type of T-BOW