Abstract:Abstract Currently, there is a deficit of experimental data for surface heat transfer characteristics and thermal transport processes associated with tip gap flows, and a lack of understanding of performance and behavior of film cooling as applied to blade tip surfaces. As a result, many avenues of opportunity exist for development of creative tip configurations with innovative external cooling arrangements. Overall goals of the present investigations are to reduce cooling air requirements, and reduce thermal loading, with equivalent improvements of thermal protection and structural integrity. Described is the development of experimental facilities, including a Supersonic/Transonic Wind Tunnel and linear cascade, for investigations of surface heat transfer characteristics of transonic turbine blade tips with unique squealer geometries and innovative film cooling arrangements. Note that data from past investigations are used to illustrate some of the experimental procedures and approaches which will be employed within the investigation. Of interest is development of a two-dimensional linear cascade with appropriate cascade airfoil flow periodicity. Included are boundary layer flow bleed devices, downstream tailboards, and augmented cascade inlet turbulence intensity. The present linear cascade approach allows experimental configuration parameters to be readily varied. Tip gap magnitudes are scaled so that ratios of tip gap to inlet boundary layer thickness, ratios of tip gap to blade axial chord length, and ratios of tip gap magnitudes to blade true chord length match engine hardware configurations. Ratios of inlet boundary layer thickness to tip gap range from 3 to 5. Innovative film cooling configurations are utilized for one blade tip configuration, and scaled engine components are modelled and tested with complete external cooling arrangements. Blade tip and geometry characteristics are also considered, including squealer depth and squealer tip wall thickness. With these experimental components, results will be obtained with engine representative transonic Mach numbers, Reynolds numbers, and film cooling parameters, including density ratios, which are achieved using foreign gas injection with carbon dioxide. Transient, infrared thermography approaches will be employed to measure spatially-resolved distributions of surface heat transfer coefficients, adiabatic surface temperature, and adiabatic film cooling effectiveness.

Investigation on film cooling and aerodynamic performance of blade tip with tangential jet cooling scheme at transonic flow

Transpiration Cooling of High Pressure Turbine Vane with Optimized Porosity Distribution

Investigation of the film-cooling and flow characteristics of trapezoidal slot scheme on the blade tip with partial pressure side squealer in transonic flow

An Experimental Study of Turbine Vane Film Cooling Using Endoscope-Based PSP Technique in a Single-Passage Wind Tunnel

Investigation on Film Cooling and Aerodynamic Performance of the Multi-Cavity Tip with Inclined Film Holes in a Linear Turbine Cascade

Experimental and Numerical Investigations into the Blade Tip Phantom Cooling Performance

Investigation into the Film Cooling Performance of Multi-Cavity Tips with Different Cavity Depths

Experimental study about the tip phantom cooling with different cooling-hole configurations on the blade-surface

Experimental and Numerical Evaluation of the Film Cooling Characteristics of the Multi-cavity Tip with Inclined Film Holes

Experimental Comparisons of Film Cooling Performance for the Multi-Cavity Tips at Two Different Tip Gaps

Thermal Performance of Transonic Cooled Tips in a Turbine Cascade

An Investigation on Film Cooling and Aerodynamic Performance of Squealer Blade Tip with Inclined Cavity Bottom

Linear Cascade and Wind Tunnel Development for Turbine Blade Tip Heat Transfer Investigations With and Without Film Cooling

Multi-parameter influence on film cooling of blade tip

An Experimental and Numerical Study on the Blade Tip Conjugate Heat Transfer Performance

Influence of Film Hole Arrangement on Cooling and Aerodynamic Performance of Blade Tip with Squealer Structure

An Experimental Investigation of Adiabatic Film Cooling Effectiveness and Heat Transfer Coefficient on a Transonic Squealer Tip

Aerothermal Performance of Different Tips in Transonic Turbine Cascade with End-Wall Motion

Effects of Suction Surface Near Tip Coolant Injection on the Aerodynamics of Tip Leakage Flow in a High-Pressure Turbine Cascade

Aerothermal characteristics evaluation for different tip configurations without and with film cooling on transonic turbine

Experimental and Computational Assessment into the Heat Transfer for the Blade Multicavity Tips