Abstract:This paper presents a 27.7-31.2 GHz highly integrated 8-element 4-beam transmitter front end in 65-nm CMOS for phased-array applications. The proposed hybrid variable-gain amplifier (VGA) combines digital common-source (CS) VGA and analog Gilbert-cell-based VGA to realize a large tuning range and high resolution simultaneously. Furthermore, the proposed VGA scheme also integrates with an active combining network to implement a compact multi-beam structure. In the vector-modulation-based phase shifter (PS), low/high pass lumped delay lines are inserted between CS transistors and common-gate (CG) transistors to form I/Q signals which drive four pairs of Gilbert-cell based G(m)-arrays for different phase states. In addition, the output element leverages a symmetrical transformer-based Doherty power amplifier (PA) and an analog adaptive bias to improve the power-back-off (PBO) efficiency with a high peak-to-average-ratio (PAPR) modulation signal. With a 1.1-V supply voltage, this front end achieves a saturated output power (P-sat) of 19.2 dBm with a 20.5% channel efficiency and a 1-dB compression point (OP1dB) of 18.2 dBm. The measured maximum drain efficiency (DE) is 40.8% and 6-dB PBO DE is 28%. Compared with class-B/A PAs, the DE is improved by 40%/180%. The proposed hybrid VGA achieves a 27-dB tuning range and a 0.25-dB gain step with 0.26 dB/1.9 degrees RMS gain/phase errors. The active PS implements 6-bit 360 degrees phase shifting with 0.25 dB/2.5. RMS gain/phase errors.

A digital power amplifier with FIR-embedded 1-Bit high-order ΔΣ modulation for WBAN polar transmitters

The Design of All-Digital Polar Transmitter Based on ADPLL and Phase Synchronized ΔΣ Modulator

A Delta-Sigma-based Transmitter Utilizing FIR-embedded Digital Power Amplifiers

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

13.7 A 0.23mm2 Digital Power Amplifier with Hybrid Time/amplitude Control Achieving 22.5dbm at 28% PAE for 802.11G

A 120 Pj/bit ΔΣ-Based 2.4-Ghz Transmitter Using FIR-Embedded Digital Power Amplifier.

A Quadrature Digital Power Amplifier With Wide Efficiency Enhancement Coverage and High Dynamic Power Range

1.2–3.6 GHz 32.67 Dbm 4096-QAM Digital PA Using Reconfigurable Power Combining Transformer for Wireless Communication

A 120 pJ/bit $DeltaSigma$ -Based 2.4-GHz Transmitter Using FIR-Embedded Digital Power Amplifier

1.2–2.8-Ghz 32.4-Dbm Digital Power Amplifier with Balance-Compensated Matching Network

A Time-Mode-Modulation Digital Quadrature Power Amplifier Based on 1-bit Delta–Sigma Modulator and Hybrid FIR Filter

A 4.1 W Quadrature Doherty Digital Power Amplifier with 33.6% Peak PAE in 28nm Bulk CMOS.

A 15-Bit Quadrature Digital Power Amplifier With Transformer-Based Complex-Domain Efficiency Enhancement

Digitally Equalized CMOS Transmitter Front-End with Integrated Power Amplifier

A Power-Efficient All-Digital Ir-Uwb Transmitter with Configurable Pulse Shaping by Utilizing A Digital Amplitude Modulation Technique

A 3.5–9.5 GHz compact digital power amplifier with 39.3% peak PAE in 40nm CMOS technology

A Transformer-Based Quadrature Doherty Digital Power Amplifier With 4.1 W Peak Power in 28 nm Bulk CMOS

A Flip-Chip-Packaged 25.3 dBm Class-D Outphasing Power Amplifier in 32 nm CMOS for WLAN Application

A Ka-Band CMOS Power Amplifier With OP1dB Improvement Employing a Diode-Connected Analog Linearizer

A High-Efficiency Two-Stage GaAs HBT Doherty Power Amplifier with Thermal Compensation for WLAN Application

A Compact Dual-Band Digital Polar Doherty Power Amplifier Using Parallel-Combining Transformer.