Energy-Efficient Hybrid Analog and Digital Precoding for MmWave MIMO Systems with Large Antenna Arrays

Xinyu Gao,Linglong Dai,Shuangfeng Han,Chih-Lin I,Robert W. Heath

DOI: https://doi.org/10.1109/jsac.2016.2549418

IF: 16.4

2016-01-01

IEEE Journal on Selected Areas in Communications

Abstract:Millimeter wave (mmWave) MIMO will likely use hybrid analog and digital precoding, which uses a small number of RF chains to reduce the energy consumption associated with mixed signal components like analog-to-digital components not to mention baseband processing complexity. However, most hybrid precoding techniques consider a fully connected architecture requiring a large number of phase shifters, which is also energy-intensive. In this paper, we focus on the more energy-efficient hybrid precoding with subconnected architecture, and propose a successive interference cancelation (SIC)-based hybrid precoding with near-optimal performance and low complexity. Inspired by the idea of SIC for multiuser signal detection, we first propose to decompose the total achievable rate optimization problem with nonconvex constraints into a series of simple subrate optimization problems, each of which only considers one subantenna array. Then, we prove that maximizing the achievable subrate of each subantenna array is equivalent to simply seeking a precoding vector sufficiently close (in terms of Euclidean distance) to the unconstrained optimal solution. Finally, we propose a low-complexity algorithm to realize SIC-based hybrid precoding, which can avoid the need for the singular value decomposition (SVD) and matrix inversion. Complexity evaluation shows that the complexity of SIC-based hybrid precoding is only about 10% as complex as that of the recently proposed spatially sparse precoding in typical mmWave MIMO systems. Simulation results verify that SIC-based hybrid precoding is near-optimal and enjoys higher energy efficiency than the spatially sparse precoding and the fully digital precoding.