Abstract:To enhance the energy-absorbing capacity of the energy absorber, the circular metal foam-filled tube (CMFFT) under external inversion over a circular die is designed. According to the rule of energy conservation, a theoretical model for the inversion of the CMFFT over a circular die is proposed, considering the radial bending of the CMFFT and the circumferential expansion of the CMFFT in the contact region and disengaging region, and the foam compression. Then, the die inversion deformation of the CMFFT under axial compression is investigated by the commercial software ABAQUS/Explicit. It is seen that the analytical model captures the numerical results reasonably. Next, the influences of the strength of the metal filled foam, the circular corner radius of the die, the average radius of the metal circular tube and the wall thickness of the metal circular tube are discussed. It is found that the force increases with the strength of the metal filled foam and the average radius of the metal circular tube. In addition, the force firstly decreases and then increases with the increase of the radius of the circular die and the wall thickness of the metal circular tube. The absorbed energy increases with the wall thickness of the metal circular tube, the circular corner radius of the die, the average radius of the metal circular tube, and the strength of the metal filled foam. The optimum radius of the circular die is proposed based on the theoretical model. The special energy absorption (SEA) efficiency of the CMFFT under external inversion over a circular die is significantly better than the metal empty tube. The SEA ratio of the CMFFT is 130.21 σ_F = 0.0694 . It is demonstrated that the CMFFT under external inversion over a die is a good energy absorber.

A revised theoretical model for external inversion process over a circular die

A Theoretical Model of the Inversion Tube over a Conical Die

Theoretical Model of a Metal Tube under Inversion over Circular Dies

An Improved Theoretical Model of a Metal Tube under Free External Inversion

Mechanical analysis of the deformation produced by internal inversion on round tubes

Analysis of the free external inversion of circular tubes based on deformation theory

The Deformation Mechanism Analysis of a Circular Tube under Free Inversion

A three-dimensional model of circular tube under quasi-static external free inversion

An Analytical Model for the Collapsing Deformation of Thin-Walled Rectangular Tube in Rotary Draw Bending

An Improved Two-Arcs Deformational Theoretical Model of the Expansion Tubes

A Theoretical Model of the Shrinking Metal Tubes

A Novel Efficient Energy Absorber: Circular Metal Foam-Filled Tube under External Inversion over a Die

Free deformation mechanism and change of forming mode in tube inversion under conical die

A Theoretical Study of the Expansion Metal Tubes

Experimental study on internal inversion of metal tube under axial load

A Study on Plastic Wrinkling in Thin-Walled Tube Bending Via an Energy-Based Wrinkling Prediction Model

Deformation Behavior of Tube in Electromagnetic Forming with an External Die

Experimental and FE Simulation Study on Cross-Section Distortion of Rectangular Tube under Multi-Die Constraints in Rotary Draw Bending Process

Optimization of an Asymmetric Thin-Walled Tube in Rotary Draw Bending Process

Process optimization of the inverting—forming of thin-walled tubes with radiused dies

The Straightening Curvature-radius Model for the Thin-walled Tube and It's Validation