Solution processed 8-hydroquinolatolithium as effective cathode interlayer for high performance polymer solar cells.

Wenqing Liu,Tao Liang,Qi Chen,Zhikai Yu,Yingying Zhang,Yujing Liu,Weifei Fu,Feng Tang,Liwei Chen,Hongzheng Chen
DOI: https://doi.org/10.1021/acsami.6b00327
IF: 9.5
2016-01-01
ACS Applied Materials & Interfaces
Abstract:Solution processed 8-hydroxyquinolinatolithium (s-Liq) was successfully applied as an efficient cathode interlayer in bulk heterojunction polymer solar cells (PSCs), giving rise to enhancement in device performance. The ultraviolet photoelectron spectra results revealed that the presence of s-Liq could lower work function of Al cathode, allowing for the ohmic contacts with the fullerene acceptor for better electron extraction and also a larger work function difference between the two electrodes, which leads to an increase in open-circuit voltage (Voc). Scanning Kelvin probe microscopy study on the surface potential of active layers suggested that an interfacial dipole was formed in s-Liq interlayer between the active layer and Al cathode, which enhanced the intrinsic built-in potential in the device for better charge transportation and extraction. Consequently, the Voc, fill factor and current density of the device can be improved by the introduction of s-Liq interlayer, leading to a power conversion efficiency (PCE) improvement. With PTB7 (or PTB7-Th) as donor and PC71BM as acceptor, the s-Liq based PSC devices exhibited a PCE of 8.37% (or 9.04%), much higher than those of devices with the evaporated Liq (7.62%) or commonly used PFN (8.14%) as cathode interlayer. Moreover, the s-Liq based devices showed good stability, maintaining 75% (in N2) and 45% (in air) of the initial PCE after 7 days, respectively. These results suggest the great potential of s-Liq as cathode interlayer material for high performance solar cells application.
What problem does this paper attempt to address?