Abstract:Magnetic energy loss P of SiFe steel represents a key factor for the efficiency of soft magnetic machine cores. Traditionally, they are operated with 50 Hz (or 60 Hz), a frequency value that yields rather balanced portions of hysteresis loss and eddy current loss. In equivalent circuits of transformers, P tends to be represented by a magnetic power resistance R M, as a constant. For the most important case of sinusoidal induction B of 50 Hz, this would correspond to an instantaneous magnetization power function p(t) that is sinusoidal as well, however, with 100 Hz (or 120 Hz). On the other hand, from complex, non-linear mechanisms of hysteresis, it is obvious that p(t) should be strongly non-sinusoidal, even for exactly sinusoidal B(t). So far, almost all corresponding instantaneous investigations were restricted to calculated modelling of loss portions and transient modelling. On the other hand, for the first time, the present study was focussed on functions p(t) as measured at IEC-standardized samples of industrially relevant steel. Practical evaluations are discussed with respect to the revealed "history" of magnetization processes, as well as for product characterization. For these tasks, a novel digitized "Low-mass Single Sheet Tester" was developed that was applied for both non-oriented steel (NO) and grain-oriented steel (GO), for 50 Hz. Interpretations proved to be favoured by relating p(t) to total P, according to an instantaneous power ratio. As a result, both steel types revealed strongly non-sinusoidal power functions, with short durations of negative p. Negative p proved to be most pronounced for NO steel, as a measure for the onset of reversible turns of atomic moments. As a consequence, p(t) comprises strong upper harmonics of 200 Hz and even 300 Hz. Based on theoretical considerations, we split p(t) in a dissipative loss power function p L(t) and in a potential energy power function p P(t). Finally, we used p(t) to determine the corresponding power resistance R M(t) that proves to be a distinctly nonlinear function as well. It resembles a rectified co-sinus, also exhibiting short negative spikes that reflect the crystallographic dis-orientation of the polycrystalline material.

Rotational Core Loss of Silicon Steel Laminations Based on Three-Dimensional Magnetic Properties Measurement

Comprehensive Magnetic Properties Analysis of the Silicon Steel Considering the Laminated Direction

Study on Influence of Processing Methods on Loss Coefficients of Iron Loss Model

Magnetic Properties Measurement Of Silicon Steel By A High Frequency 2-D Magnetization Structure

Measurement of Alternating and Rotational Magnetostrictions of Non-oriented Silicon Steel Sheets

Design of A 3-D Rotational Magnetic Properties Measurement Structure for Soft Magnetic Materials

Measurement and Modelling of Rotational Anomalous Loss Considering Skin Effect of Electrical Steel Sheets

Simulation Model for Loss Measurement of Electrical Steel and Study on the Influence of Harmonics

Calculation of core loss under distorted flux density with minor hysteresis loops for laminated steel structure

Comparison and analysis of testing methods for magnetic properties of oriented silicon steel sheets

Predicting Iron Losses in Laminated Steel with Given Non-Sinusoidal Waveforms of Flux Density

Influence of temperature on magnetic properties of silicon steel lamination

Core loss measurement and comparative analysis for soft magnetic materials under complex non-sinusoidal excitations

Physically consistent multi-frequency magnetic loss testing of silicon steel

Measurements of Iron Loss in PMSM Stator Cores Based on CoFe and SiFe Lamination Sheets and Stemmed From Different Manufacturing Processes

A DC Differential Method for Core Loss Measurement under Sinusoidal Excitation

Magnetic Properties of Silicon Steel after Plastic Deformation

Practical Aspects of Instantaneous Magnetization Power Functions of Silicon Iron Laminations

Measurement of Three-Dimensional Magnetic Properties with Feedback Control and Harmonic Compensation.

Comprehensive magnetic properties of grain-oriented silicon steel sheet considering anisotropy under mechanical stress

Comparative Analysis of Core Loss Calculation Methods for Magnetic Materials Under Nonsinusoidal Excitations