The Impact of Modeling Liquids on Surface Roughness and Color Properties of Bulkfill Resin Composites After Simulated Tooth Brushing: An in Vitro Study. Part I

Camila Falconí‐Páez,Claudia González‐Vaca,Juliana Guarneri,Newton Fahl,Paulina Aliaga‐Sancho,Maria Lujan Mendez‐Bauer,Cesar Augusto Galvão Arrais,Andrés Dávila‐Sánchez
DOI: https://doi.org/10.1111/jerd.13314
2024-09-20
Journal of Esthetic and Restorative Dentistry
Abstract:Objective To evaluate the effect of different modeling agents on color changes, surface roughness, and translucency parameters over time in Bulkfill resin composites. Material and Methods Sixty specimens were prepared using three Bulkfill resin composites (Tetric N‐Ceram Bulkfill, Filtek One Bulkfill and Opus Bulkfill) and three modeling agents (Wetting Resin, Optibond FL and Ambar APS). All specimens were subjected to a simulated tooth‐brushing (Baseline, 50.000 cycles, 100.000 cycles), and surface roughness was measured at each interval. Surface topography was evaluated. The translucency parameter and color changes were assessed after 24‐h, 7‐, 14‐ and 30‐day immersion in water, wine, and coffee. Data was analyzed using ANOVA and Bonferroni test. Results All specimens increased roughness after simulated tooth‐brushing (p
dentistry, oral surgery & medicine
What problem does this paper attempt to address?