Complex shapes of lithium disilicate glass-ceramics developed by material extrusion
Manuel F.R.P. Alves,Claudinei dos Santos,I. Duarte,Maria H.F.V. Fernandes,Susana M.H. Olhero
DOI: https://doi.org/10.1016/j.addma.2024.103973
IF: 11
2024-01-12
Additive Manufacturing
Abstract:The fabrication of high-end ceramics by additive manufacturing gained increasing research interest due to the capacity of these techniques to break through the limitations of traditional extractive manufacturing. Although efficient strategies for the processing of ceramic materials by additive manufacturing have been shown, with notable examples in the dental field, the processing of dense glass-ceramics by the same means is almost unexplored. Herein, a processing strategy for the manufacture of complex shapes of lithium disilicate glass-ceramics by material extrusion is detailed shown for the first time. An aging behaviour was observed on the glass loaded aqueous suspensions and in-deep studied, being related with the leaching of Li + ions. Based on this, a hydrogel-based ink with high solid content (φ≈ 50 vol%), suitable rheological properties (G ́≈10 6 and τ ≈1500 Pa) and recovery time was developed. By using the optimized ink, a propeller component with high aspect ratio and small internal connected channels, as well as a dental crown were successfully printed. A debinding schedule was tuned by the combination of differential thermal analysis and hot stage microscopy. The sintered lithium disilicate glass-ceramic parts presented good relative density (≈ 96.7 ± 0.8%) and translucency. Outstanding mechanical properties were achieved (Hv ≈5.3 GPa, K If ≈2.1 MPa.m 0.5 , σ ≈279 ± 44 MPa), comparable to values usually attained for these materials by powder technology. The low deviation of the flexural strength data reported here is related with the absence of meaningful processing defects on the analysed fracture surfaces and the homogeneous distribution of the residual porosity as microporous, resulting in a good Weibull characteristic strength σ 0 = 301 MPa. The results of the present work emphasized the potential of Direct ink Writing, a material extrusion technique, to fabricate lithium disilicate glass-ceramic parts with complex geometries, as dental crowns.
engineering, manufacturing,materials science, multidisciplinary