Abstract:Solvent engineering has been extensively used to control the growth of a high-quality perovskite layer for solar cells by forming intermediate phases. However, the intermediate phase formation is often poorly understood and its effects on the perovskite layer growth are still elusive. Here, we have conducted a systematic and in-depth study on the above two issues through a strict control over the DMSO/DMF ratio in CH3NH3PbI3 perovskite solutions, and thus an effective control over the compositions of intermediate films. The films thus obtained, including perovskite, perovskite/MA2Pb3I8(DMSO)2 and MA2Pb3I8(DMSO)2, afford perovskite crystals via down-growth, down-and up-growth, and up-growth mechanisms, respectively. Significantly, the up-growth perovskite crystals from the pure MA2Pb3I8(DMSO)2 exhibits the best interface contact with NiO substrate, optimal alignment without horizontal grain boundaries and a relatively large grain size, which facilitate charge transfer and reduce charge recombination in PSCs. As a result, the PIN planar PSCs based on NiO have achieved a PCE of 18.4%, a value which is among the highest for NiO-based PSCs, with the highest stability among the tested sample cells. Furthermore, the pure MA2Pb3I8(DMSO)2 intermediate phase presents a high long-term stability, which enlarges the operating window for perovskite deposition and thus considerably improves the device processibility.

Effects of Innbo4 Fabrication on Perovskite Pin-Pmn-Pt

Effects of Nano-Sized In2O3on Sintering Behavior and Electrical Properties of 0.28Pb(in1/2nb1/2)o3-0.40Pb(mg1/3< /Sub>nb2/3)o3-0.32Pbtio3ceramics

Design Morphotropic Phase Boundary Composition in the Pb(In1/2Nb1/2)O3-Pb(Mg1/3Nb2/3)O3-PbTio3 System and Its Performance

Effects of Na Excess on the Preparation and Characterization of (K0.5na0.5)nbo3ceramics

Effects of Annealing on Dielectric and Ferroelectric Properties in Pb(In1/2Nb1/2)O3–xPbTiO3(x≤0.30) Ceramics

Study on the inhomogeneity of Pb(In1/2Nb1/2)O3–Pb(Mg1/3Nb2/3)O3–PbTiO3 single crystal along the growth direction

Phase diagram and properties of Pb(In 1/2Nb 1/2)O 3-Pb(Mg 1/3Nb 2/3)O 3-PbTiO 3 polycrystalline ceramics

Phase diagram and properties of high TC/TR-T Pb (In 1/2 Nb1/2) O3- Pb(Zn1/3 Nb 2/3) O3-PbTiO3 ferroelectric ceramics

Effects of annealing technique and TiO2 seed layer on the phase composition of 0.7Pb(Mg1/3Nb2/3)O3–0.3PbTiO3 film

Effects of MnO2 addition on the structure and electrical properties of PIN-PZN-PT ceramics with MPB composition

Growth and Electrical Properties of Pb(In0.5Nb0.5)O3–PbTiO3 Crystals by the Solution Bridgman Method

A complete set of material properties of single domain 0.26Pb(In(12)Nb(12))O(3)-0.46Pb(Mg(13)Nb(23))O(3)-0.28PbTiO(3) single crystals.

Effects of Mn-Doping on PIN-PMN-PT Ceramics with MPB Composition

Electromechanical properties of Pb(In(1∕2)Nb(1∕2))O(3)-Pb(Mg(1∕3)Nb(2∕3))O(3)-PbTiO(3) single crystals.

Effects of co-doping the SnO2 electron transport layer with boron and indium on the photovoltaic performance of planar perovskite solar cells

Electromechanical Properties of Pb(In1/2Nb1/2)O3–Pb(Mg1/3Nb2/3)O3–PbTiO3 Single Crystals

A Pure and Stable Intermediate Phase is Key to Growing Aligned and Vertically Monolithic Perovskite Crystals for Efficient PIN Planar Perovskite Solar Cells with High Processibility and Stability

Ynthesis of Pure Perovskite Phase PMN - PT by Modified Columbite Precursor Method

Nanoscale Insight into the Domain Structures of High Curie Point Pb(In1/2Nb1/2)O3-PbTiO3 Single Crystal

High Composition Uniformity of 4″ of PIN-PMN-PT Single Crystals Grown by the Modified Bridgman Method