Abstract:By pulsed laser deposition (PLD) method ferroelectric BaTiO3 nanofilms were grown on Si substrates coated by nanoporous alumina membranes (NAMs) with an average pore size of 20 nm,and metal Pt nanowires were embedded in NAMs as a part of the bottom electrode. The dielectric and ferroelectric properties,and microstructure of the BaTiO3 nanofilms were characterized. The results showed that the dielectric constant of the BaTiO3 nanofilms with a thickness of 170 nm,decreased slowly from 400 to 350 as the measured frequency was increased from 103 Hz to 106 Hz,and that the dielectric loss increased slowly from 0.029 to 0.036 in the low frequency range from 103 Hz to 105 Hz,whereas quickly increased up to 0.07 at high frequencies over 105 Hz. Such a phenomenon was resulted from the dielectric dipolar polarization in the BaTiO3 nanofilms. Polarization-electric field hysteresis loop indicated that the remanent polarization and the coercive field of the BaTiO3 nanofilms were 17 μC/cm2 and 175 kV/cm,respectively. Cross-sectional (scanning) transmission electron microscopy (TEM) images demonstrated that the BaTiO3 nanofilms contacted directly with the Pt nanowires,and the interface between them had some degree of waviness. Both selected area electron diffraction and high-resolution TEM images confirmed that the BaTiO3 nanofilms were the tetragonal phase with a perovskite structure. After post-annealing and crystallization of the BaTiO3 nanofilms,some Pt nanowires became branches at their ends due to the re-growth of the Pt nanowires. A suitable post-annealing temperature is the critical processing parameter of fabricating ferroelectric ordered nanostructures as considering a trade-off between the ordered metal nanowires within NAMs and the crystallinity of ferroelectric nanofilms.

Fabrication and Piezoelectric Property of BaTiO3 Nanofibers

Fabrication of Lead-Free (na0.82k0.18)0.5bi0.5tio3 Piezoelectric Nanofiber by Electrospinning

Fabrication, Structural and Humidity Sensing Properties of BaTiO3 Nanofibers Via Electrospinning

Dielectric and Ferroelectric Properties of BaTiO3 Nanofibers Prepared Via Electrospinning

Enhancing Electrical Properties of High-Curie Temperature Piezoelectric Ceramics BNT-PZT and Their Mechanism

Sol‐Gel Routes to Nanostructured Patterned Ferroelectric Thin Films with Novel Electronic and Optical Functions

Fabrication and Piezoresponse of Electrospun Ultra-Fine Pb(Zr0.3, Ti0.7)O3 Nanofibers

Fabrication, physical property and microstructural characterization of ferroelectric BaTiO3 nanofilms

Preparation of Nano-Structured BaTiO3 Thin Film by Electrophoretic Deposition and Its Characterization

Preparation of Ti Doped BaFe12O19 Ceramics by a Sol-Gel Process

Synthesis, Electrical and Humidity Sensing Properties of Batio3 Nanofibers Via Electrospinning

Crystallization, phase evolution and ferroelectric properties of sol-gel-synthesized Ba(Ti0.8Zr0.2)O3-x(Ba 0.7Ca0.3)TiO3 thin films

Facile Preparation and Performance of Novel High-Tc Xbi(ni1/2ti1/2)o3-(1-x)pb(zr1/2ti1/2)o3 Piezoceramics

Enhancement of Piezoelectric and Ferroelectric Performances in (na0.85k0.15)0.5bi0.5tio3 Films with BaTiO3 Interlayers

Grain-size dependence of piezoelectric properties in thermally annealed BaTiO3 ceramics

Structure and Electrorheological Properties of Nanoporous BaTiO3 Crystalline Powders Prepared by Sol–gel Method

BiScO3-PbTiO3 nanofibers piezoelectric sensor for high-temperature pressure and vibration measurements

Composition dependence of structural and piezoelectric properties in Bi(Mg0.5Ti0.5)O3-modified BaTiO3-BiFeO3 ceramics

Enhanced piezotronics by single-crystalline ferroelectrics for uniformly strengthening the piezo-photocatalysis of electrospun BaTiO 3 @TiO 2 nanofibers

Fabrication of barium titanate ceramics via digital light processing 3D printing by using high refractive index monomer

Synthesis and characterization of barium titanate nanoplatelets/polyvinylidene fluoride nanocomposite for piezoelectric properties