Abstract:Vehicle occupant’s contact with the interior structure is the second collision at a crash event following the vehicle collision to foreign objects. Vehicle interior structure such as door trim, arm rest, instrumental panel, knee bolster, pillar trim, roof trim, and seat pad are made of various kinds of plastics and foams. The deformation and failure of these materials largely affect the kinematics and injury risks of the occupant. The major effort on virtual simulations of car crashworthiness has been focused on the precise modeling of load carrying primary metallic structures and crash dummies until now. The objective of this study is to advance the numerical modeling scheme of vehicle interior materials for their mechanical behaviors to simulate more realistic response of dummy kinematics and its associated injury risks. Plastic materials exhibit softening, dilatational, pressure dependent and anisotropic characteristics which should be considered during the modeling process as vehicle interior parts. In this paper, pros and cons of various material types in a crash code were comparatively analyzed. Both conventional modeling method for the steel material and Phenomenological model in LS-DYNA were respectively used to simulate plastic materials. Few coupon tests were conducted to identify basic material data for the Phenomenological model. Seating occupant is basically supported by the car seat and their interactions during the crash event affect the kinematics of occupant. The dynamic force-indentation characteristics of low density urethane foam at seat cushion and back are newly analyzed by measuring the exhalant airflow at impact test of pre-strained seat foams with trimming cover. A constitutive equation taking this airflow through the trimming into account is under development and to be built in the existing material library of crash code.

Three-Dimensional Finite Element Modeling and Front Crash Process Analysis of Car Bodywork

Finite Element Analysis on the Lateral Crashworthiness of Car Body Structure

Analysis and Improvement for Key Parts of Car Based on Frontal Crashworthiness Simulation

Body Structure Optimization of a Car in the Frontal Crash

Numerical Simulation and Test Validation of Vehicle Frontal Crash

Research and Analysis of Frontal Collision of Passenger Cars Based on ANSYS

Simulation of Automobile Offset Frontal Impact and Structure Improvement

Modeling and Simulation of Frontal Crash Performance of a Minibus

Frontal crashworthiness structure analysis and optimization of electric vehicle

Simulation Analysis of Inner Force Characteristics of Car Body Thin-walled Beam Structures Subject to Lateral Impact

Optimization Design of Longitudinal Beam Structure in Car Frontal Crash

A review on finite element modelling and experimental analysis of crashworthiness design of automotive body

Optimization Design of Body Structure in Offset Crash

Improvement of vehicle crashworthiness for full frontal impact based on energy flow analysis

Advanced FE Modeling of Vehicle Interior Structures to Enhance the Prediction for Crash Induced Injury Risk of the Occupant

FEM Simulation of Pedestrian-Vehicle Accidents Based on Parameters of Chinese Human Body

Numerical simulation of crashworthiness parameters for design optimization of an automotive crash-box

The Safety of Body Structure and Occupant Protection Research of Medium Bus Under Three Kinds of Frontal Impact Forms

Application of Sub-Structure Method for Automotive Side Impact Simulations

Modeling Multi-View Scenario of Driving Simulation on Typical Side-Impact Accidents

Finite Element Crash Analysis of a Rear-Engine Automobile