Abstract:Abstract. Vibration damper is widely used in overhead transmission lines to alleviate aeolian vibration. Its natural frequencies are important parameters for a vibration damper. In this paper, the approximate calculation formulas of natural frequencies of the one-side subsystem of a Stockbridge type vibration damper were derived and the design sensitivity analysis of the natural frequencies was studied using partial differential equations with respect to each concerned parameter including the length of the steel strand, the mass of the counterweight, the eccentric distance, and the radius of gyration of the counterweight. Through a case study that considered a variation of up to ±30 % in the values of the design parameters, the exact calculation and approximate calculation results of the natural frequencies were analysed, and the sensitivity of the vibration damper's natural frequencies to the design parameters was studied. The results show that, within the range of the parameters used in this study, the approximately calculated first-order frequency is lower than the exact values, whereas the approximately calculated second-order frequency is larger than the exact values. The sensitivity analysis indicates that the first-order frequency is highly sensitive to the steel strand's length, whereas it is moderately sensitive to the counterweight's mass and slightly sensitive to the eccentric distance and the gyration radius of the counterweight; the second-order frequency is highly sensitive to the steel strand's length and the gyration radius of the counterweight, moderately sensitive to the counterweight's mass, and slightly sensitive to the eccentric distance. It will provide theoretical guidance and approximate analysis method in engineering for the design of the vibration damper.

Frequency Response Analysis of Truss Spar by Considering the Viscous Damping

NEW WIND-INDUCED RESPONSES ANALYSIS METHOD OF SPATIAL STRUCTURES IN FREQUENCY DOMAIN WITH MODE COMPENSATION

Modal Frequency and Stability of Rotor System Supported by Viscoelastic Elastomeric Dampers

Nonlinear static analysis of space truss using vector mechanics of structure

Assessment of Ultimate Strength of a Typical Truss Spar Using Nonlinear Finite Element Analysis

Physical Essence and Influence of Model Parameters on Dynamic Response of Rayleigh Damping

Analytical study on the aerodynamic and hydrodynamic damping of the platform in an operating spar-type floating offshore wind turbine

Response Adjustable Performance of a Visco-Elastomer Sandwich Plate with Harmonic Parameters and Distributed Supported Masses under Random Loading

Investigation into the Potential Use of Damping Plates in a Spar-Type Floating Offshore Wind Turbine

Experimental and numerical studies on the low-frequency responses of a spar-type floating offshore wind turbine

Response of Liquid in Cylindrical Tank with Rigid Annual Baffle Considering Damping Effect

Coupled modeling and structural vibration control for floating offshore wind turbine

The surge-heave-pitch coupling motions of the Φ-type vertical axis wind turbine supported by the truss Spar floating foundation

Design analysis and experimental verification of vibration reduction of spatial composite damping truss structure

Dynamic response of asymmetric suspended structure subjected to random wind excitation

Dynamic Response of Spar Wind Turbine Moored by Dynamic Catenaries Under Random Wind and Wave Loads

ANALYSIS OF MODAL PROPERTIES OF BEAMS WITH VISCO-ELASTIC SUPPORT JOINTS

The approximate calculation of the natural frequencies of a Stockbridge type vibration damper and analysis of natural frequencies' sensitivity to the structural parameters

Frequency-dependent aerodynamic damping and its effects on dynamic responses of floating offshore wind turbines

Analysis of Tall Buildings with Damped Outriggers

An efficient spectral method for the dynamic behavior of truss structures