Abstract:There must be an end gap in the piston ring because of the need of mounting and compensation for diameter after the wear of ring. Richardson’ and many author’ studies have showed the effects of the end gap to blowby and oil consumption, especially in the presence of ring or liner wear. This problem has influenced the effective utilization of the fuel energy for many years. Moreover the ring will rotate in the working cycle of engine. Once the end gaps of two compression rings come to the site of superposition, the shortest passage of gas flow is formed and blowby will be increased. The deflection of crankpin and rotation of piston were calculated according to the analytical model based on the torque transmission theory of crankshaft. The positive and negative deflections of crankpin result in the reciprocating rotation of piston in the IC engine working cycle. The peak values of deflection and rotation are in the vicinity of crank angle position of deflagration. Because the clingy moment of compression rings are less than rotational resistance moment in a few section of crank angle, they are unable to keep synchronism with piston and the rotations opposite to piston occur. The rotation angle of the second compression ring is more than that of the first ring. The superposition of the end gaps of two compression rings comes about when they turn to the same angle position. Based on above study, the structure of one compression ring in piston system should be widely used, which is in favor of reduction of friction and engine weight, pushing forward the lightweight process, being useful to the decrease of fuel consumption and emission. The pressure of combustion gas will not remarkably descend in this structure. The problem of ring suspension and pressure release in the first ring land can be resolved. Two types of rings with complete seal and economizing energy design are showed for the structure of one ring, which will also avoid the increase of end gap after the rings are worn.

Friction Process Analysis and Ring Structure Improvement of Piston Rings in MTU396 Diesel

Impact of the Piston Secondary Motion on Its Slap Force

Dynamic Model for Cylinder-Piston Ring in Operation

Molecular Dynamics Investigation on Micro-Friction Behavior of Cylinder Liner-Piston Ring Assembly

A New Method to Reduce Frictional Power Consumption of Piston Ring in Internal Combustion Engine

Analysis on Friction Mechanism of Superposition of End Gap of Piston Ring in Internal Combustion Engine

Simulation and Experimental Investigation on Friction Reduction by Partial Laser Surface Texturing on Piston Ring

Friction and Wear Performance of Double-bump Design of Piston Skirt Main Thrust Side

Combined experimental and simulative approach for friction loss optimization of DLC coated piston rings

Study on the Three-Dimensional Tribo-Dynamic Analysis of Piston Ring Pack Considering the Influence of Piston Secondary Motion

Study of the Piston System Structure of Advantageous to Low Friction and Economizing Energy

On the Transient Three-Dimensional Tribodynamics of Internal Combustion Engine Top Compression Ring

A fully coupled tribo-dynamic model for piston-ring-liner system

Research on Improving Antifriction and Wear Resistance of Piston Ring for Internal Combustion Engine

Tribological Performance of Three Advanced Piston Rings in the Presence of MoDTC-modified GF-3 Oils

Research on the Factors Affecting the Lubrication and Frictional Characteristics of Piston Ring-liner Considering the Heat Conduction between Solid Walls

A Tribological Analysis On Stuffing Box-Piston Rod System Of Low-Speed Marine Diesel Engines

Investigation of Pressure Distribution and Frictional Heat on Self-Lubricated Piston Rings in Reciprocating Compressors

Friction Behaviour of Piston Ring for Free-Piston Engine Generator

Investigation of the Pressure Distribution and the Frictional Heat on Self-lubricated Piston Rings

A Study on Lubrication and Friction on Piston-Ring Pack in IC Engine