Abstract:The internal flow evolution of the pump was induced with impeller movement. In various conditions, the peak load on centrifugal blade under the change of rotational speed or flow rate was also changed. It would cause an error when inertia load with a safety coefficient (that was difficult to ascertain) was applied in structure design. In order to accurately analyze the impeller stress under various conditions and improve the reliability of pump, based on a mixed flow pump model, the stress distribution characteristic was analyzed under different flow rates and rotational speeds. Based on a three-dimensional calculation model including impeller, guide blade, inlet and outlet, the three-dimension incompressible turbulence flow in the centrifugal pump was simulated by using the standard k-epsilon turbulence model. Based on the sequentially coupled simulation approach, a three-dimensional finite element model of impeller was established, and the fluid-structure interaction method of the blade load transfer was discussed. The blades pressure from flow simulation, together with inertia force acting on the blade, was used as the blade loading on solid surface. The Finite Element Method (FEM) was used to calculate the stress distribution of the blade respectively under inertia load, or fluid load, or combined load. The results showed that the blade stress changed with flow rate and rotational speed. In all cases, the maximum stress on the blade appeared on the pressure side near the hub, and the maximum static stress increased with the decreasing of the flow rate and the increasing of rotational speed. There was a big difference on the static stress when inertia load, fluid load and combined loads was applied respectively. In order to more accurately calculate the stress distribution, the structure analysis should be conducted due to combined loads. The results could provide basis for the stress analysis and structure optimization of pump.

The Fluid-Structure Interaction Analysis of the Inverted Umbrella Aerator Curved Blade

Computational Fluid Dynamics Simulation of Hydrodynamics in an Uncovered Unbaffled Tank Agitated by Pitched Blade Turbines

Static Aeroelasticity Analysis of a Rotor Blade Using a Gauss-Seidel Fluid-Structure Interaction Method

Structure Designation and Dynamic Model Analysis of Folding Wing for Underwater Vehicles

Study on the internal two-phase flow of the inverted-umbrella aerator

Optimization Design of Centrifugal Fan Impeller Based on Numerical Simulation.

Experimental Study on the Principle of Oxygenation and Oxygenation Performance of Surface Blade Aerator

Fluid-structure Interaction Vibrating Properties Simulation of Kaplan Turbine Runner Blade

Numerical study of the hydrodynamic performances of surface piercing propeller

Study of flow field and vibration characteristics of supersonic centrifugal impellers based on fluid-structure interaction

Computation of Stress Distribution in a Mixed Flow Pump Based on Fluid-Structure Interaction Analysis

Dynamic Characteristic Analysis of Francis Hydro Turbine Blades with Fluid-structure Interaction

A Fluid–structure Analysis Approach and Its Application in the Uncertainty-Based Multidisciplinary Design and Optimization for Blades

Dynamic Analysis of a Francis Turbine Based on the Fluid-Structure Interaction Theorem

ANALYSIS OF FLOW-INDUCED VIBRATION OF BLADES FOR A FRANCIS HYDRO TURBINE

Iteration Design of Direct and Inverse Problems and Flow Analysis of Mixed-Flow Pump Impellers

Fem Simulation Of Turbulent Flow In A Turbine Blade Passage With Dynamical Fluid-Structure Interaction

Research on Aerodynamic Characteristic and Optimal Design of Turbine Cascades with Curved Blades at Different Attack Angles

CFD simulation and performance comparison of surface aerator for deep aeration

Modal Analysis of Francis Turbine Blade Based on Fluid-Structure Interaction Theorem

Flow Visualization and Topological Analysis of a Turbine Rotor Cascade with Tip Clearance