Numerical study on the effect of supporting pile calculation methods in pile-anchor support system
Xiaoyang Liu,Zhiguo Chen,Changming Wang
DOI: https://doi.org/10.21203/rs.3.rs-1734626/v1
2022-01-01
Abstract:Abstract In numerical analysis, the pile calculation method is a key factor in foundation pit calculation results. However, the mechanism of different pile calculation methods in the foundation pit has remained unclear. To evaluate performances of different pile calculation methods in pile-anchor support system, four pile calculation methods (equivalent solid elements without interface (Mode1), equivalent solid elements with interface (Mode2), one-dimensional structural elements (Mode3), and two-dimensional plate elements (Mode4).)were used in a typical pile-anchor pit based on FLAC3D. Results show that: there is a great influence on the computational results for different pile calculation methods: (1) solid pile elements(Mode1 and Mode2), compared with structural pile elements(Mode3 and Mode4), displacements near pile are smaller, with the increase of excavation depth, stress concentration appeared in solid pile elements. (2) Solid support pile, with interface (Mode2) compared with without interface (Mode1), the former of that was less displacement, whereas more stress concentration around the pile, which leads special points stress paths around the solid pile to become irregular. (3) Regarding structural pile elements (Mode3 and Mode4), it suggested both modeling approaches have similar effect. For this foundation pit, Mode2 is more suitable. If Mode3 and Mode4 are used for this pit design, it will obviously exaggerate the actual displacement and overestimate the construction cost. The results of this paper can provide a deeper understanding of pile calculation in pile-anchor foundation pits numerical analysis.