Abstract:Highly concentrated viscoelastic paraffin oil-in-water emulsions were prepared by using tetradecyltrimethylammonium laurate (TTAL) as the emulsifier at a water percentage of 10%. The influences of four different inorganic salts, i.e., NaCl, NaBr, CaCl2 and MgSO4, on the structures and rheological properties of the emulsions have been investigated. It was found that the addition of salt eventually induces macroscopic phase separation of the emulsions and the influence following the order of NaCl < NaBr < CaCl2 < MgSO4. At intermediate salt concentrations, the introduction of salt leads to obvious viscoelasticity enhancement of the emulsions. The ability of the salt to induce the viscoelasticity enhancement approximately follows an opposite order to that found in phase separation, which is 100 folds at 500 mmol L-1 NaCl (potentially not reach the maximum), 400 folds at 300 mmol L-1 NaBr, 10 folds at 50 mmol L-1 CaCl2 and 6 folds at 15 mmol L-1 MgSO4, respectively. It is speculated that the adsorption of the inorganic cation and anion onto the charged surfactant monolayer at the oil/water interface changes the properties of the emulsion droplets, accounting for this unusual viscoelasticity enhancement. By conductivity measurements, it is also evidenced that the dissociation and mobility of the adsorbed ions can be hardly influenced by temperature, which leads to pronounced stability of the emulsions at elevated temperatures. The salt-induced structural transitions have been monitored by optical microscopy and confocal fluorescence microscopy observations, both of which show the presence of large oil droplets surrounded by hierarchically-organized smaller ones. (C) 2016 Elsevier B.V. All rights reserved.

Research on the W/O Emulsion Stability Influenced by the Content of Salt and Surfactants

Stability Analysis of Water-in-Oil Microemulsion System

Influence of Surfactant and Weak-Alkali Concentrations on the Stability of O/W Emulsion in an Alkali-Surfactant–Polymer Compound System

Stability of oil-in-water emulsions formed in the coastal aquifer

Influences of Addition of Hydrophilic Surfactants on the W/O Emulsions Stabilized by Lipophilic Surfactants

A Study of the Stability of W/O/W Multiple Emulsions

Influence of Water Content and Temperature on Stability of W/O Crude Oil Emulsion

Stability of Water-in-oil Emulsion and Its Liquid Membrane

Influence of Surfactant Structure on the Stability of Water-in-Oil Emulsions under High-Temperature High-Salinity Conditions

Recent advances on food-grade water-in-oil emulsions: Instability mechanism, fabrication, characterization, application, and research trends

Stability studies of high-stable water-in-oil model emulsions

EFFECT OF INORGANIC SALTS ON THE PROPERTIES AND MICROSTRUCTURE OF O/W EMULSION PREPARED BYSODIUM PETROLEUM SULFONATE

Properties of Emulsions Formed In Situ In a Heavy-Oil Reservoir during Water Flooding: Effects of Salinity and pH

Review on the Stability Mechanism and Application of Water‐in‐Oil Emulsions Encapsulating Various Additives

Viscoelasticity Enhancement Induced by Salts for Highly Concentrated Oil-in-water (O/W) Emulsions

Stability Mechanism of W/O Crude Oil Emulsion Stabilized by Polymer and Surfactant

Insights into the Relation of Crude Oil Components and Surfactants to the Stability of Oily Wastewater Emulsions: Influence of Asphaltenes, Colloids, and Nonionic Surfactants

The Stability of W/O/W Double Emulsions and Its Application in Food Industry

A numerical and experimental investigation into the influence of CO2 on the stability of W/O emulsion

The Influence of Different Treatments and Different Additives on The Stability of O/W Emulsion

Effect of inorganic electrolytes on the formation and the stability of water-in-oil (W/O) emulsions