Abstract:Understanding the initiating and suppression mechanisms of existing defects are the key to optimizing the ultra-precision grinding process of hard and brittle materials. This paper discusses the effects of grinding damage on material removal mechanism from the perspectives of residual scratch depth, scratch morphology and normal scratching force, through conducting the contrast variable-depth nano-scratch experiment on polished and ground monocrystalline silicon and establishing the single grain scratching Smoothed Particle Hydrodynamics (SPH) model. The experimental and simulation results show that radial crack on ground silicon surface is almost invisible due to the existence of grinding marks, which indicates that it is difficult to judge the ductile brittle transition (DBT) point by the traditional method of observing cracks. With the increase of penetration depth, pop-in will occur in the residual scratch depth of polished and ground silicon, indicating that the material removal mode has transformed, which provides an important basis for judging the DBT point. The DBT critical normal scratching force (38.93 mN) and residual scratch depth (−0.14 μm) of ground silicon are much higher than those of polished silicon, implying ground silicon is easier to achieve ductile processing. Meanwhile, when the penetration depth is the same, compared to polished silicon, the normal scratching force of ground silicon is generally larger. Finally, a single grain scratching SPH model of pre-stressed silicon is established. And the simulated phenomenon and conclusions are consistent with the experiment, which proves that the surface compressive stress is an important factor that causes the removal characteristics of ground silicon to be different from polished silicon. This study provides a theoretical basis for understanding the ultra-precision grinding removal mechanism of hard and brittle materials.

The Force in Single-Pass Scratch Tests at Variable Sliding Velocities

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Prediction and Verification Analysis of Grinding Force in the Single Grain Grinding Process of Fused Silica Glass

Fundamental abrasive contact at high speeds: scratch testing in experiment and simulation

Insights into scratching force in axial ultrasonic vibration-assisted single grain scratching

Effect of grinding damage on cutting force and ductile machining during single grain scratching of monocrystalline silicon

A material point method based investigation on crack classification and transformation induced by grit geometry during scratching silicon carbide

Investigation of Modeling on Single Grit Grinding for Martensitic Stainless Steel

Investigation of Cutting Force and the Material Removal Mechanism in the Ultrasonic Vibration-Assisted Scratching of 2D-SiCf/SiC Composites

Damage Mechanisms of Material in Single-Cone Scratching

A 3D multi-scratch test model for characterizing material removal regimes in 5083-Al alloy

Cross-point effect of high-speed cross scratch on hard brittle materials

Force Characteristics in Continuous Path Controlled Crankpin Grinding

Coupling of double grains enforces the grinding process in vibration-assisted scratch: Insights from molecular dynamics

Interference mechanism and damage accumulation in high-speed cross scratches on hard brittle materials

Implementation of AFM Tip-Based Nanoscratching Process on Single Crystal Copper: Study of Material Removal State

Frictional Characteristic Curves of Ground Surfaces in Lubricated Sliding

A novel multi-pass dual-indenter scratch test to unravel abrasion damage formation in construction steels

Cutting Speed Dependence of Material Removal Mechanism for Monocrystal Silicon

Effect of material removal state on the selection of theoretical models when scratching single-crystal copper using the load modulation approach