Abstract:A combined experimental and numerical study was carried out to explore the dynamic response of Q235 thin-walled cylindrical shells under lateral shock loading. The machined Q235 specimens were clamped on both sides and subjected to centered lateral simulated shock loading via foam projectile impact tests, with their dynamic deformation evolution, mid-point deflections, and final deformation modes experimentally measured. The mid-point deflections of the impact side are all positive (the direction of deformation is the same as the impact direction) while those of the rear side all exhibit negative values (the direction of deformation is opposite to the impact direction). To further explore this phenomenon, the method of finite element (FE) was employed to simulate the foam projectile impact, with good agreement against experimental measurements achieved. Using the validated numerical model, the effects of impact velocity, length-to-diameter ratio, and thickness-to-diameter ratio on the dynamic response of the thin-walled cylindrical shell were further analyzed. The direction of both side deflections and deformation modes are significantly affected by the impact level and the shell geometries. For the rear side, within the given range of impact momentum, the numerically predicted deflection varies from -1.775 mm to 2.45 mm. Thereupon, the coupling of indentation and bulge deformation patterns are indicated, and their corresponding contribution changes are considered the main mechanism for determining the final deformation of the thin-walled cylindrical shell's rear side.

Strain Measurement in the Steel Shell Surface Impacted by a Falling Ball

Axial Impact Behaviors of Stub Concrete-Filled Square Steel Tubes

DYNAMIC RESPONSE OF CLAMPED METALLIC THIN-WALLED CYLINDRICAL SHELLS UNDER LATERAL SHOCK LOADING

STUDY ON DEFORMATION CONTROL METHOD OF SHALLOW SPHERICAL SHELLS UNDER IMPACT LOADS

Impact Experiment and Buckling Criterion Analysis of Thin-Walled Cylindrical Shells

Experiment and numerical simulation of thin-walled cylindrical containers subjected to lateral impact

Experimental investigation into scaling laws for conical shells struck by projectiles

Mechanism of Microscopic Fracture of Typical Shell Steel under Impact Loading

Identification of material parameters at high strain rates using ballistic impact tests and inverse finite element analysis

Experimental Measurements of 2169 Stainless-Steel under Dynamic Loading

Measurement and calculation of impact stresses in ball mills

Experimental and numerical analysis of laterally impacted stiffened plates considering the effect of strain rate

Measurement of Dynamic Fracture Parameters of Explosive Cylindrical Shells

Simulation of the Deformation and Failure Characteristics of a Cylinder Shell under Internal Explosion

Strain Growth in a Finite-Length Cylindrical Shell under Internal Pressure Pulse

Study of Impact Process of Air Arc on the Chamber Shell Based on the Interaction of Fluid–Structure Method

Dynamic Simulation Analysis of the Mid-Strain-Rate Tensile Testing Machine

Experimental Investigation of the Dynamic Responses of Thin-Walled and Foam-Filled Steel Tubes Subjected to Repeated Impacts

Numerical Analysis of Deformation and Failure of Penetration into Concrete Target by Projectile

Measurement of Dynamic Fracture Parameters in the Expansion Process at High Strain Rate

Behaviors of Thin-Walled Cylindrical Shell Storage Tank under Blast Impacts