Abstract:The deep sea harbors abundant mineral, oil, and gas resources, making it highly valuable for commercial development, including the extraction of minerals. Due to the relatively large particle size of these minerals, how they interact with fluids is significantly different from that of small particles. However, there has been limited simulation research on the impacts of large particles (the diameter of particles is at the level of centimeters) on the flow and wear characteristics in bends, because the simulation of the particles at such a size is difficult. Additionally, in the field of deep-sea mining, multiple bends are simultaneously connected in series, and the wear in such bends has garnered increasing attention. Based on an improved CFD-DEM model, this article solved the issue that traditional unresolved CFD-DEM methods cannot accurately simulate large particles in a hydraulic conveying pipe and bend. After validating the accuracy of this model against classical experiments, the paper comprehensively analyzes the modulation effect of large particles on turbulence, and the effects of different particle diameters, particle transport concentrations, and transport velocities on the wear of bends connected serially. Finally, the bends connected serially in various configurations are simulated to study the wear on the bent interior surfaces. Results indicate a pronounced modulation effect of large particles on turbulence at higher transport concentrations; the wear rate in the combined bends does not exhibit a linear correlation with the collision frequency of particles on the wall surface. Furthermore, different configurations of serially connected bends exhibit significant differences in the wear morphology of the second bend.

Numerical Simulation of Salt Particle - Supercritical Water Flow in a 90° Bend Pipe

Molecular Dynamics Simulations on Salt Deposition and Nucleation in Supercritical Water

CFD-DEM Analysis of Hydraulic Conveying Bends: Interaction Between Pipe Orientation and Flow Regime

Numerical Investigation on Deposition Rate of Mechanically Mixed Ash Particles in an Entrained Flow Reactor

Numerical Simulation of the Melting of Solid Particles in Thermal Convection with a Modified Immersed Boundary Method

Numerical Simulation of Adiabatic/cooled/heated Spherical Particles with Stefan Flow in Supercritical Water

Numerical Investigation of the Impacts of Large Particles on the Turbulent Flow and Surface Wear in Series-Connected Bends

Numerical Simulation of Salt-out Flow in Centrifugal Pump Based on Population Balance Model

Validation of a Eulerian-Lagrangian numerical algorithm for simulating ultra-coarse particles transported in horizontal and vertical hydraulic pipes

Numerical simulation of fluid-particle flow of jet in supercritical water environment

CFD ANALYSIS OF FLOW PATTERN AND HEAT TRANSFER OF WATER JET INTO SUPERCRITICAL WATER ENVIRONMENT

CFD-DEM analysis of hydraulic conveying of non-spherical particles through a vertical-bend-horizontal pipeline

Distribution characteristics of salt crystals in a supercritical water fluidized bed reactor with CFD-PBM coupled model

Numerical Investigation on the Drag Characteristics of Supercritical Water Flow Past a Sphere

Numerical Investigation of the Effect of Surface Roughness on Flow and Heat Transfer Characteristics of Single Sphere Particle in Supercritical Water

Analysis of Heat Transfer of Supercritical Water by Direct Numerical Simulation of Heated Upward Pipe Flows

Mixed Convection Heat Transfer from a Particle in Supercritical Water

Simulation of Solid-Fluid Interaction in a Supercritical Water Fluidized Bed with a Cold Jet

Numerical Simulation on Condensation Heat Transfer of the Satured Steam Around a High Speed Sub-Cooling Water Jet

Application of CFD to Study the Flow in a Molten Salt Chlorination Furnace