Abstract:Optimising the performance of materials requires, among other things, the characterisation of residual stresses during the design stage. Raman spectroscopy offers access to these residual stresses at the micrometre scale when this inelastic light scattering is active in these materials. In this case, the relationship between the Raman mode shift and the pressure must be known. High-pressure cells with diamond anvils or bending instruments coupled to Raman spectrometers are habitually used to determine this relationship. In this article, we propose a new method that involves a Hertzian contact to obtain this relationship. A device that compresses an alumina ball against a transparent glass plane is connected to a Raman spectrometer. Under these conditions, the contact pressure can be as high as 1.5 GPa. The contact between the glass plane and the ball is observed through a diaphragm. Several hundred Raman spectra are recorded depending on the contact diameter. The spectral profiles obtained represent the shift in the Raman modes of alumina and glass along the contact diameter. Hertz's theory accurately describes the pressure profile as a function of position for elastic materials. Therefore, the contact diameter can be measured by fitting the spectral profile with a function identical to the Hertz profile. We then deduce the maximum pressure. Next, the calculated pressure profile along the contact diameter is correlated with the spectral profile. We obtain a pressure dependence of the Raman mode with a coefficient equal to 2.07 cm-1/GPa for the Eg modes of alumina at 417 cm-1, which is in good agreement with the literature. In the case of glass, we refine the measurement of the Q3 mode shift at 1096 cm-1 in the studied pressure range compared to the literature. We find a coefficient of 4.31 cm-1/GPa. This work on static contacts opens up promising prospects for investigations into dynamic contacts in tribology.

Phonon Deformation Potentials for the Corundum Structure of Sapphire

Structural relaxations around Ti, Cr and Fe impurities in alpha-Al2O3 probed by x-ray absorption near edge structure combined with first-principles calculations

First-Principles Study of High-Pressure Alumina Polymorphs

Floating zone growth and optical phonon behavior of corundum Mg4Ta2O9 single crystals

Crystal structure of a high-pressure/high-temperature phase of alumina by in situ X-ray diffraction

Chemical mechanical polishing (CMP) anisotropy in sapphire

Study of Raman Spectra for Γ-Al2o3 Models by Using First-Principles Method

Assessing thermochemical properties of materials through ab initio quantum-mechanical methods: the case of α-Al2O3

Electronic Structure of High-pressure Alumina Polymorphs

Optical Transitions In Ruby Across The Corundum To Rh2o3 (Ii) Phase Transformation

Rotational Reconstruction of Sapphire (0001)

Theoretical investigations of the physical properties of zircon-type YVO 4

Determination of the Pressure Dependence of Raman Mode for an Alumina-Glass Pair in Hertzian Contact

Experimental Study of Ultrasonic Vibration Assisted Chemical Mechanical Polishing for Sapphire Substrate

Raman Spectrometry Study Of Phase Stability And Phonon Anharmonicity Of Al3bc3 At Elevated Temperatures And High Pressures

Surface structure of protonated R-sapphire (1102) studied by sum-frequency vibrational spectroscopy.

Surface Piezoelectricity of (0001) Sapphire

Surface Structure Of Protonated R-Sapphire (1(1)Over-Bar02) Studied By Sum-Frequency Vibrational Spectroscopy

Chromium hardening and Peierls mechanism for basal slip in sapphire at temperatures between 900 and 1500 $^\circ$C

A Study of Chemical Products Formed on Sapphire (0001) During Chemical–mechanical Polishing

Optical Transitions in Ruby Across the Corundum Torh2o3(ii) Phase Transformation