Temperature Dependence of the Radiation Tolerance of Nanocrystalline Pyrochlores A2Ti2O7 (A = Gd, Ho and Lu)
J. Wen,C. Sun,P. P. Dholabhai,Y. Xia,M. Tang,D. Chen,D. Y. Yang,Y. H. Li,B. P. Uberuaga,Y. Q. Wang
DOI: https://doi.org/10.1016/j.actamat.2016.03.025
IF: 9.4
2016-01-01
Acta Materialia
Abstract:A potentially enhanced radiation resistance of nanocrystalline materials, as a consequence of the high density of interfaces and surfaces, has attracted much attention both to understand the fundamental role of these defect sinks and to develop them for high-radiation environments. Here, irradiation response of nanocrystalline A(2)Ti(2)O(7) (A = Gd, Ho and Lu) pyrochlore powders with grain sizes of 20-30 nm was investigated by 1-MeV Kr2+ ion bombardment. In situ transmission electron microscopy (TEM) revealed that the critical amorphization fluence for each nanocrystalline compound at room temperature was greater than that for their coarse-grained counterparts, indicating an enhanced amorphization resistance. The effect of temperature on the irradiation response of one of these compounds, nanocrystalline Lu2Ti2O7, was further examined by performing ion irradiation at an elevated temperature range of 480 -600 K. The critical amorphization temperature (T-c) was found to be noticeably higher in nanocrystalline Lu2Ti2O7 (610 K) than its coarse -grained counterpart (480 K), revealing that nanocrystalline Lu2Ti2O7 is less resistant to amorphization compared to its coarse -grained phase under high temperatures. We interpret these results with the aid of atomistic simulations. Molecular statics calculations find that cation antisite defects are less energetically costly to form near surfaces than in the bulk, suggesting that the nanocrystalline form of these materials is generally less susceptible to amorphization than coarse grained counterparts at low temperatures where defect kinetics are negligible. In contrast, at high temperatures, the annealing efficiency of antisite defects by cation interstitials is significantly reduced due to the sink properties of the surfaces in the nanocrystalline pyrochlore, which contributes to the observed higher amorphization temperature in the nano -grained phase than in coarse -grained counterpart. Together, these results provide new insight into the behavior of nanocrystalline materials under irradiation. (C) 2016 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.