Abstract:In recent years, nanotechnology has been applied to building materials, such as cementitious composites (e.g., mortar and concrete), to improve their properties. The aim of this study was to analyze the thermal, physical, and mechanical properties of mortars with and without silicon-dioxide (SiO2) nanoparticles. Experiments such as thermogravimetry and differential thermal analysis (TG-DTA), X-ray diffraction (XRD), fresh density, incorporated-air content, bulk density, capillary absorption, capillarity coefficient, flexural tensile strength, and compressive strength on prismatic specimens were performed on mortars and analyzed for different levels of nanosilica (nS). These levels were 1% and 3%, in addition to the reference mortar (0% nS). The TG-DTA curves showed an elevated content of chemically combined water and a lower content of calcium hydroxide (Ca(OH)2) in the 3% nS compositions, while the XRD curves presented a lower content of calcite and portlandite in the same mortar. These results indicate the fixation capacity of lime for the formation of calcium silicate hydrate (C-S-H), which is the primary cause of resistance in cementitious mortars. In addition, it was found that the use of nanosilica contributed to a fresh density increase of approximately 15%, which caused a minimum air-incorporated content decrease of 37% and a minimum bulk density increase of 10%. Higher densities resulted in a minimum water absorption reduction of 36%, owing to fewer pores in the mortars. Therefore, the capillarity coefficient decreased by a minimum of 41%. These nanoparticles also improved the minimum flexural tensile and compressive strengths by 88% and 158%, respectively, when using a 3% nS composition. These results can enable the use of lightweight aggregates in cementitious composites, improving their physical and mechanical characteristics and allowing greater reuse of these materials, including construction waste.

Influence of Nanoparticles on Fluidity and Mechanical Properties of Cement Mortar

Investigations on the Preparation and Mechanical Properties of the Nano-Alumina Reinforced Cement Composite

Influence of silicon-dioxide nanoparticles in cementitious mortars: verification using X-ray diffraction, thermal analysis, physical, and mechanical tests

Combined Effect of Nano Ferrite and Nano Silica onProperties of Cement Mortar

Effect of Nano-Tio2 on the Mechanical Properties of Cement Mortar

Study on the Influence of Nanosilica Sol on the Hydration Process of Different Kinds of Cement and Mortar Properties

Modification Effects of Carbon Nanotube Dispersion on the Mechanical Properties, Pore Structure, and Microstructure of Cement Mortar

Recent Progress in Nanomaterials for Modern Concrete Infrastructure: Advantages and Challenges

Effect of nanomaterials on the mechanical properties and microstructure of cement mortar under low air pressure curing

Comparative Overview of the Performance of Cementitious and Non-Cementitious Nanomaterials in Mortar at Normal and Elevated Temperatures

Effect of nano materials on cementitious mortar composites exposed to sulphate attack

Experimental investigation on the effect of incorporating nanomaterials on some properties of self-compacting cementitious mortar

A Comparative Study on the Influence of Nano and Micro Particles on the Workability and Mechanical Properties of Mortar Supplemented with Fly Ash

Comparative study on mechanisms for improving mechanical properties and microstructure of cement paste modified by different types of nanomaterials

Effect of Different Particle Sizes of Nano-Sio2 on the Properties and Microstructure of Cement Paste

Effects of Nano-CaCO_3 Intermediate on Physical and Mechanical Properties of Cement-based Materials

Effect of Nano-SiO2 on the Mechanical Properties, Microstructure, and Hydration Process of Cementitious Materials Incorporating Hydrophobic Admixture

Synergistic effects of CNTs/SiO2 composite fillers on mechanical properties of cement composites

Experimental Study on Properties of Cement Mortar with Micro-Nano Bubble Water

Effect of Nano Compound Addition on the Properties and Microstructure of Cement Mortar with Mixed Fine Recycled Aggregate

Study on the reinforcing mechanisms of nano silica to cement-based materials with theoretical calculation and experimental evidence