Abstract:Carbon nanotubes (CNTs) and their composites are gaining popularity due to their exceptional strength qualities. It is well known that adding CNTs to metal foam composites boosts compressive strength. On the other hand CNT addition is still a costly process due to high cost of the CNTs. This study presents a novel and cost-effective solution by selectively adding CNTs to the structurally weakest regions of aluminum foam materials produced via powder metallurgy, employing a newly developed focused multi-step additive method. The cell borders of aluminum foam are strengthened with multiple spherical layers of CNTs, using a transfer method by initially coating the space holders used at the foaming process. The strength increase effect of this CNT addition method was compared with the widely known aluminum foam production parameters via a 4-parameter design of experiment (DOE) study. Compressive strength values of the samples were evaluated using a constant speed compression test acc. to ISO13314. The compacting pressure, CNT concentration, sintering temperature, and sintering period were chosen as DOE parameters, and 78% of the interactions effecting on final compressive strength could be explained with the model. As a result, it was established that, compared to the other parameters, sintering duration had the highest influence on compressive strength. But besides It has also been shown that adding 0.53% CNT by weight only to the cell border regions increases overall strength by 9%. This weight-strength increase ratio is compared with similar studies in the literature and found to be providing a production cost advantage due to the lower amount of CNT addition requirement for the comparable weight relative strength increase. Focused strength increase method has potential to enable controlled failure of foam materials by selectively strengthening strength critical areas of a component.

A Novel Approach to Obtain In-Situ Growth Carbon Nanotube Reinforced Aluminum Foams with Enhanced Properties

Enhanced Mechanical Properties of Novel Aluminum Foams Synergistically Reinforced by NiO Particles and in Situ Grown Carbon Nanotubes

Compressive Response and Energy Absorption Characteristics of In-Situ Grown CNT-Reinforced Al Composite Foams

Carbon-nanotube-templated Carbon Nanofibers with Improved Mechanical Performance

Synthesis of uniformly dispersed carbon nanotube reinforcement in Al powder for preparing reinforced Al composites

Research on compression-compression fatigue properties of carbon nanotubes reinforced closed-cell aluminum matrix composite foams by reinforcement content design

Fabrication of Carbon Nanotube Reinforced Al Composites with Well-Balanced Strength and Ductility

Fabrication and characterization of closed-cell aluminum foams with different contents of multi-walled carbon nanotubes

Investigation on microstructures, compressive properties and energy absorption capacity of carbon nanotubes/aluminum composite foam-filled tubes

Enhancement of the Mechanical Strength of Aluminum Foams by SiC Nanoparticles

Enhanced Mechanical Behavior and Fabrication of Silicon Carbide Particles Covered by In-Situ Carbon Nanotube Reinforced 6061 Aluminum Matrix Composites

In-situ Homogeneous Synthesis of Carbon Nanotubes on Aluminum Matrix and Properties of Their Composites

Effect of Carbon Nanotube (CNT) Content on the Properties of In-Situ Synthesis CNT Reinforced Al Composites

In-Situ Carbon Nanotube-Covered Silicon Carbide Particle Reinforced Aluminum Matrix Composites Fabricated by Powder Metallurgy

In-situ Synthesis of CNTs@Al2O3 Wrapped Structure in Aluminum Matrix Composites with Balanced Strength and Toughness

Innovative reinforcement method for metal foam cell wall using CNTs

Printability enhancement and mechanical property improvement via in situ synthesis of carbon nanotubes on aluminium powder

Synthesis of Carbon Nanotube Reinforced Al Matrix Composites Via Cold Spray Deposition

Synthesis of carbon nanotube reinforced Al matrix composite coatings via cold spray deposition

Processing and Characterisation of Carbon Nanotube-Reinforced Magnesium Alloy Composite Foams by Rapid Microwave Sintering

Carbon Nanotubes Grown on Graphite Films as Effective Interface Enhancement for an Aluminum Matrix Laminated Composite in Thermal Management Applications