OPTIMIZATION OF THE RESERVE-TYPE DISTRIBUTOR FOR R410A AIR CONDITIONER

Chi Zhang,Ying Wang,Jiangping Chen
DOI: https://doi.org/10.1142/s2010132514500229
2014-01-01
International Journal of Air-Conditioning and Refrigeration
Abstract:Mal-distribution of refrigerant in a cross-flow type evaporator with parallel paths is very important, which can lead to a loss of heat exchanger capacity to 25%. Distributors are used to balance the two-phase refrigerant distributions in each path. Apart from the structural factors, there are other factors influencing the performance of distributor greatly. In this paper, influences of several nonstructural factors on reservoir distributor are investigated experimentally under varied working conditions. The inlet tube configuration, installation orientation and capillary tube length are also studied. One experiment apparatus is developed to measure the refrigerant mass flow rate and the quality based on R410A air conditioner. It is found that influence caused by inlet tube before the distributor is small. The average STD is only 2.76%. Influence caused by orientation is broad. The average STD is less than 9% on the orientation of 15°. On the orientation of 90°, STDs of different conditions are all more than 40%. For orientation, mass flow rate sensitivity is larger than quality sensitivity. Capillary tubes with different length can be used to adjust distribution. Average STD with sizable capillary length difference is 9.47%. It means that only small mal-distribution can be adjusted by using different-length capillary tubes. Capillary tube length sensitivity increases with the increase of difference between outlet tubes or the decrease of average length of outlet tubes.
What problem does this paper attempt to address?